Toshiba D-R17DTKB owner manual Auto Tuning Analog, Manual Tuning Analog, 24 EN

E7J70BD_EN.book Page 24 Monday, May 7, 2007 3:31 PM

Auto Tuning (ANALOG)

ANALOG

Programme the tuner to scan only the channels you can receive in your area.

1 In stop mode, press [SETUP]. Select “General Setting” using [U / D], then press [ENTER/OK].

General Setting Menu will appear.

2 Select “Channel” using [U / D], then press [ENTER/OK].

3 Select “ANALOG Channel Setup” using [U / D], then press [ENTER/OK].

4 Select “Auto Tuning” using [U / D], then press [ENTER/OK].

The unit will start storing channels available in your area.

General Setting
Playback
Display	Auto Tuning (DVB & ANALOG)
Video	DVB Channel Setup
Recording	ANALOG Channel Setup
Clock	ANALOG Channel Setup
	Auto Tuning
Channel
DivX	Manual Tuning
HDMI	Move
Reset All

Wait for several minutes to finish channel storing.

•Analogue channels will be stored in channel 901-999 after it is scanned by this unit.

5 Press [SETUP] to exit.

You can select only the channels memorised in this unit by using [PROG. / ].

To cancel auto tuning

Press [RETURN/BACK] or [SETUP] during scanning.

Note

•The selection will be affected by how you receive TV channels in your local area.

•If the auto tuning is cancelled during scanning, some channels not yet tuned may not be received.

•You cannot change the channel when DVD is in any recording mode (normal recording, One-touch Timer Recording or timer recording).

Manual Tuning (ANALOG)

ANALOG

You can preset an analogue channel manually and individually.

1	In stop mode, press [SETUP]. Select
	“General Setting” using [U / D],
2	then press [ENTER/OK].
	Select “Channel” using [U / D], then
3	press [ENTER/OK].
	Select “ANALOG Channel Setup”
	using [U / D], then press
4	[ENTER/OK].
	Select “Manual Tuning” using
5	[U / D], then press [ENTER/OK].
	Select “Position” using [U / D], then
	press [P].
		Manual Tuning
			Position	901
			Channel	1
			Decoder	OFF
			Skip	ON

6 Select the position number you wish to use using [the Number buttons] or [U / D], then press [L].

•You can select position number 901-999.

•With [the Number buttons], you only need to enter the last 2 digit numbers.

7 Select “Channel” using [U / D], then press [P].

8 Press [U / D] to start scanning.

•The tuner will begin to search up or down automatically. When a channel is found, the unit will stop searching and the picture will appear on the TV screen.

•You can select a desired channel number using [the Number buttons]. Refer to the following Channel Plan table and press the three digits to select the channel number.

(To select channel 4, press [0] first and then press [0] and [4]. Or press [4] and then “– – 4” appears and wait for 2 seconds.)

•If this is the channel you want, press [L].

Channel Plan

CH Indication		TV Channel
01	– 10	IRA-IRJ, GAP
21	– 69	E21 – E69
74	– 78	X, Y, Z, Z+1, Z+2
80 – 99, 100		S1 – S20, GAP
121	– 141	S21 – S41

24 EN