Toshiba 19SLV411U manual Moisture condensation may occur in the following situations

Removing the Pedestal Stand

1)Carefully lay the front of the TV face down on aflat, cushioned surface such as a quilt or blanket. Leave the stand protruding over the edge of the surface.

Note: Extreme care should always be used when removing the pedestal stand to avoid damage to the LCD panel.

2)Remove the four screws shown in the below diagram. This will allow removal of the pedestal stand.

3)Once you have removed all four screws, holding the pedestal stand in place, remove the pedestal stand from the TV.

19SLV411U VESA Mounting Pattern

24SLV411U VESA Mounting Pattern

~":"E5~Chl..~J:liii)~":"E5~5"

~,:::~.:

Four screws L --'

32SLV411 U VESA Mounting Pattern

CAUTION: Always place the TV on the floor or a sturdy, level, stable surface that can support the weight of the unit. To secure the TV, use a sturdy strap from the hook(s) on the rear of the TV to awall stud, pillar, or other immovable structure. Make sure the strap is tight, secure, and parallel to the floor.

Notes on moisture condensation

Moisture condensation damages the unit. Please read the following carefully.

Moisture condensation occurs, for example, when you pour a cold drink into a glass on awarm day and drops of water form on the outside of the glass. In the same way, moisture may condense on this unit's internal optical pick-up lens, one of the most crucial internal parts of the unit.

Moisture condensation may occur in the following situations:

•When you move the unit from a cold area to a warm area.

•When you use the unit in a room in which the heat was just turned on.

•When you use the unit in an area where cold air from an air conditioner directly hits the unit.

•When you use the unit in a humid area.

o o o o 0 o f\ 'O-- --£:::: :~~~rm!J

-p------

:;: ' - '"III

l~~ ~::~~\\\

r---~_,-'--"- ,,;---	:::::l	', -
________.L-_----	.:~	,
		-!.!-J

Never use the unit when moisture condensation may occur.

Using the unit when moisture condensation exists may damage discs and internal parts. Connect the power cord of the unit to the wall outlet, turn on the unit, remove the disc, and leave it for two or three hours. After two or three hours, the unit will have warmed up and evaporated any moisture. Leaving the TV connected to the wall outlet will help prevent moisture condensation in the unit.

Four screws	Hook
	Sturdy strap
	(as short as possible)

6