Toshiba 19SL410U To Display your LCD TV using a Wall Bracket, 100x100 mm IOOx 100 mm 200x200 mm

45)If you have the TV serviced:

•Ask the service technician to use only replacement parts specified by the manufacturer.

•Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

Choosing a location for your LCD TV

To Display your LCD TV on the included Pedestal Stand:

Observe the following safety precautions:

1)Read and Follow the pedestal assembly instructions included with the pedestal.

CAUTION: Before beginning pedestal assembly, carefully lay the front of the LCD Panel face down on a flat, cushioned surface such as a quilt or blanket. Leave the bottom of the unit protruding over the edge of the surface and assemble the pedestal as indicated below.

Note: Extreme .care should always be used when attaching the pedestal stand to avoid damage to the LCD panel.

2)Place the TV on a sturdy, level surface that can support the weight of the TV.

3)Be sure to secure the TV to a wall, pillar, surface, or other immovable structure. (1& item 25, page 3).

To Display your LCD TV using a Wall Bracket:

If you decide to wall mount your LCD TV, always use a UL listed wall bracket appropriate for the size and weight of the LCD TV (1& page 2):

1)CAUTION: Two people are required for installation.

2)Unplug and remove any cables and/or other compo- nent connectors from the rear of the TV.

3)Remove the screws of the VESA Mounting Pattern show in the next page.

CAUTION: Do not use the screws removed from the back cover to attach the wall mount bracket to the TV.

4)Always use the screws supplied or recommended by the wall mount manufacturer.

5)Follow the instructions provided with your wall bracket. Before proceeding, make sure the appropriate bracket(s) are attached to the wall and the back of the TV as described in the instructions provided with the wall bracket.

6)After attaching the appropriate bracket(s) to the wall and the back of the TV, remove the pedestal stand from the TV as described on the following page.

1)VESA Mounting Pattern

19"	100x100 mm	M4
24"	IOOx 100 mm	M4
32"	200x200 mm	M6

(unit in mm)

Removing the Pedestal Stand

1)CarefUlly lay the front of the unit face down on a flat, cushioned surface such as aquilt or blanket. Leave the stand protruding over the edge of the surface.

Note: Extreme care should always be used when removing the pedestal stand to avoid damage to the LCD panel.

2)Remove the four screws shown in the below diagram. This will allow removal of the pedestal stand.

3)Once you have the four screws that hold the pedestal stand in place, remove the pedestal stand from the TV.

19/24" TV VESA Mounting Pattern

	Hook
32"lV	Sturdy strap
	(as short as possible)
	VESA Mounting Pattern

Hook Sturdy strap

(as short as possible)

FCC Declaration of Conformity Compliance Statement (Part 15):

The Toshiba 19S1410U, 24Sl410U, and 32Sl410U

Televisions comply with Part 15 of the FCC rules. Operation is subject to the following two conditions:

(I)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.

The party responsible for compliance to these rules is: Toshiba America Information Systems, Inc.

9740 Irvine Blvd.; Irvine, CA 92618 Ph: 1-800-631-3811

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance wIth the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by removing and applying power to the equipment, the user IS encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications to this equipment not expressly approved by Toshiba courd void the user's authority to operate this equipment.

5