Toshiba SD-KV540SU owner manual Troubleshooting, Symptom Cause Correction, Scan Mode

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.

Symptom	Cause	Correction
No power.	The power cord is disconnected.	Plug the power cord into the wall out-
		let securely.
The power is on, but	DVD or VCR button is not switched	Refer to page 7.
the DVD+VCR does not	properly.
work.
	No disc is inserted.	Insert a disc or tape. (Check that the
	No tape is inserted.	disc or tape indicator in the display
		window is lit.)
No picture.	The TV is not set to receive DVD+VCR	Select the appropriate video input
	signal output.	mode on the TV so the picture from
		the DVD+VCR player appears on the
		TV screen.
	The video cable is not connected	Connect the video cable into the jacks
	securely.	securely.
	Mismatch setting between TV and this	Select the correct Video Output in
	unit.	SETUP menu.
	Wrong connection.	Check the connection.
No sound.	The equipment connected with the	Select the correct input mode of the
	audio cable is not set to receive	audio receiver so you can listen to the
	DVD+VCR signal output.	sound from the DVD+VCR.
	The audio cables are not connected	Connect the audio cable into the jacks
	securely.	securely.
	The power of the equipment connected	Turn on the equipment connected with
	with the audio cable is turned off.	the audio cable.
	The AUDIO options are set to the wrong	Set the AUDIO options to the correct
	position.	position.
The playback picture is	The disc is dirty.	Clean the disc.
poor.
	The TV channels are not tuned in properly.	Check tuning, carry out tuning again.
	Tape heads are dirty.	Clean video heads.
	Tape is a rental or was recorded on	Use CH/TRK (+/-) for manual tracking
	another VCR.	adjustment while tape is playing.
	This unit can only output 525p	Make sure that your TV can support
	Progressive scan picture.	525p Progressive scan picture or set
		Progressive scan to off.
The “PROGRESSIVE	DVD+VCR was turned off while setting	Press and hold the STOP button for
SCAN MODE”	the Progressive scan mode.	more than 5 seconds.
message remains to be	The Progressive Scan was set to “On”
displayed.
	in the SETUP menu but is connected to
	a standard(analog) television with com-
	ponent video input.

38