Additional information | 08 |
Troubleshooting
Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical appliances being used. If the trouble cannot be rectified after checking the items below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.
Problem
The disc won’t play or is automatically ejected after loading.
Remedy
•Make sure the disc is free from dirt and dust and is not damaged (page 45).
•Make sure the disc is loaded with the label side
•Incompatible region number: If the region number on a
•Condensation inside the player: Allow time for condensation to evaporate. Avoid using the player near an
•Disc is loaded upside down: Reload the disc with the label side face up.
•A Super VCD that does not conform with the IEC standards might not play normally.
•Check that the disc is not a DualDisc or other incompatible format disc (page 8).
• The disc may have been illegally copied. | ||
stops. | ||
| ||
|
| |
Picture playback stops | • Press , then start playback again ( ). | |
and the operation | • Press and hold the front panel STANDBY/ON button for about 10 | |
buttons cannot be used. | seconds to switch the unit off, then press again to switch back on. | |
| • Switch the power off once, unplug from the wall socket, then plug | |
| back in and switch on again using the front panel STANDBY/ON | |
| button. | |
|
| |
New settings made in the | • Some settings can be changed while a disc is playing, but are not | |
Setup screen menus while | effective until the disc is stopped then restarted: Press , then start | |
a disc is playing are | playback again ( ). | |
ineffective. |
| |
|
| |
Settings are canceled. | • When the power is cut due to power failure or by unplugging the | |
| power cord, settings will be canceled: Press STANDBY/ON on the | |
| front panel to turn the player off. Wait for | |
| the display, then unplug the power cord. | |
|
| |
The remote control | • The remote control is too far from the player, or the angle with the | |
doesn't seem to work. | remote sensor is too wide: Use the remote within its operating range | |
| (page 17). | |
| • The batteries are exhausted: Put in new ones (page 7). | |
|
|
49
En