Pioneer DV-79AVi-s operating instructions Additional information

Page 80

09Additional information

This player is designed for use with conven- tional, fully circular discs only. Use of shaped discs is not recommended for this product. Pioneer disclaims all liability arising in connection with the use of shaped discs.

Cleaning the pickup lens

The DVD player’s lens should not become dirty in normal use, but if for some reason it should malfunction due to dust or dirt, consult your nearest Pioneer-authorized service center. Although lens cleaners for CD players are commercially available, we do not recommend using them since some may damage the lens.

Problems with condensation

Condensation may form inside the player if it is brought into a warm room from outside, or if the temperature of the room rises quickly. Although the condensation won’t damage the player, it may temporarily impair its perfor- mance. For this reason you should leave it to adjust to the warmer temperature for about an hour before switching on and using.

Hints on installation

We want you to enjoy using this product for years to come, so please bear in mind the following points when choosing a suitable location for it:

Do...

Use in a well-ventilated room.

Place on a solid, flat, level surface, such as a table, shelf or stereo rack.

Don’t...

Use in a place exposed to high tempera- tures or humidity, including near radia- tors and other heat-generating appliances.

80

Place on a window sill or other place where the player will be exposed to direct sunlight.

Use in an excessively dusty or damp envi- ronment.

Place directly on top of an amplifier, or other component in your stereo system that becomes hot in use.

Use near a television or monitor as you may experience interference—especially if the television uses an indoor antenna.

Use in a kitchen or other room where the player may be exposed to smoke or steam.

Use on a thick rug or carpet, or cover with cloth—this may prevent proper cooling of the unit.

Place on an unstable surface, or one that is not large enough to support all four of the unit’s feet.

Moving the player

If you need to move the player, first press POWER on the front panel to turn the player off. Wait for --OFF--to disappear from the display, then unplug the power cable.

Never lift or move the unit during playback— discs rotate at a high speed and may be damaged.

Power cable caution

Handle the power cable by the plug part. Do not pull out the plug by tugging the cable, and never touch the power cable when your hands are wet, as this could cause a short circuit or electric shock. Do not place the unit, a piece of furniture, or other object on the power cable or pinch the cable in any other way. Never make a knot in the cable or tie it with other cables. The power cables should be routed so that they are not likely to be stepped on. A damaged power cable can cause a fire

En

Image 80
Contents DV-79AViDV-79AVi-s Wash hands after handling Grounding or Polarization POWER-CORD Caution We Want You Listening For a LifetimePage Contents Video Settings menu Initial Settings menuVideo Adjust Creating your own presetsBefore you start Chapter FeaturesBefore you start Before you start Before you start What’s in the box Putting the batteries in the remote controlUsing the remote control General disc compatibility CD-R/RW compatibilityDVD-R/RW Compatibility Super Audio CDCompressed Audio Compatibility PC Created Disc CompatibilityCDs, SACDs and Video CDs are divided into tracks Before you start Titles, chapters, groups and tracksDVD-Video regions Connecting up Connecting up ChapterRear panel Digital Audio OUT Optical / CoaxialConnecting up Control in / OUTVideo OUT 1&2 Component Video OUTConnecting up Easy connections To power outletConnecting using the component video output Connecting up Using other types of video outputConnecting using an S-Video output Connecting up Connecting for multichannel surround sound Connecting using the multichannel analog outputsConnecting using a digital audio output Digital OpticalConnecting using i.LINK Connector AV receiverAbout i.LINK Creating an i.LINK networkConnecting using Hdmi HdmiAbout Hdmi Controlling this player from another Pioneer componentControl Controls and displays Controls and displays ChapterFront panel 10 11 12Controls and displays About progressive scan videoPart PrgsveGRP TitleControls and displays Remote control JOG JOG Mode VolumeAngle SubtitleManufacturer Preset Code Setting up the remote to control your TVPreset code list Getting Started Chapter Switching onGetting Started Using the on-screen displays Press Enter again to finish setting upGetting Started Let’s Get Started Press Enter to move on to the next screenSetting up with the Setup Navigator Select ‘Setup Navigator’Getting Started Button What it doesSelect a DVD language Did you connect this player to an AV receiver?DTS Congratulations, setup is complete Getting Started Playing discs Basic playback controlsPress OPEN/CLOSE to open the disc tray Load a disc Press play to start playbackButton DVD disc menusFront panel controls Video CD PBC menus Displays the PBC menuWhy won’t the disc I loaded play? Disc may have been illegally copiedWhy does the volume level seem lower during Sacd playback? Introduction Playing discsPlaying discs Chapter Scanning discs To resume normal playback, press playPlaying discs Using the Multi Dial Playing in slow motionDuring playback, press Pause Press and hold Until Press repeatedly to change the slow motion speedPlaying discs Frame advance/frame reverse Looping a section of a discPlaying discs Using repeat play Using random playCreating a program list Select a random play optionRandom Title Random Chapter Random Off Random Group Random Track Random OffSelect ‘Create/Edit’ from the list of program options To play the program list, press play Editing a program listRepeat to build up a program List Select a program play function Searching a discOther functions available from the program menu Switching subtitles Switching the DVD audio languagePress Enter to start playback Press Subtitle repeatedly to select a subtitle optionSwitching DVD-RW audio channels Switching DVD-Audio audio channelsSwitching CD/MP3/Video CD audio channels Switching camera anglesDVD-RW displays Sacd displaysCD and Video CD Displays During PBC playback onlyAudio Settings menu Audio Settings menu ChapterDefault setting Off Audio DRCAudio Settings menu There are four settings, plus OffHi-Bit Virtual SurroundChannel Level Speaker Distance Video Settings menu Video Settings menu ChapterVideo Adjust Creating your own presetsVideo Settings menu Adjust the picture quality settingsVideo Settings menu Initial Settings menu Initial Settings menu ChapterUsing the Initial Settings Digital Audio Out settings Menu Default setting OnInitial Settings menu Dolby Digital OutDTS Out Linear PCM OutVideo Output settings Mpeg OutTV Screen Component OutLanguage settings Video OutStill Picture Audio LanguageSubtitle Language Auto LanguageDisplay settings Registering a new password OptionsBackground Screen SaverChanging your password Setting/changing the Parental Lock levelSelect ‘Password Change’ Use number buttons to enter your password, then press EnterSetting/changing the Country/Area code You may also want to refer to the Country/Area code list onBonus Group Select a new levelDVD Playback Mode Default setting SingleDefault setting DVD-Audio Auto Disc MenuSacd Playback Hdmi SettingsDefault setting 2ch Area Colour ResolutionAspect Ratio Default setting PCM Playback CD PlaybackVideo Memory AudioAudio Output Mode Speaker InstallationSpeakers DTS DownmixL and R speakers are paired you can’t set them differently Default setting all speakers 10ftSpeaker Distance Speaker Distance settings do not affect Sacd playback Channel LevelMove the cursor left to go back to Speaker Distance screenAudio Out Link SetupConnections Setup DVD-Audio Out Default setting 5.1 ChannelAuto Select Play Taking care of your player and discs Additional informationAdditional information Chapter Additional information Resetting the player Screen sizes and disc formatsWidescreen TV users Standard TV usersAdditional information About the audio output settings DTS CDAdditional information About the Hdmi output settings DTSDTS CD DTS*2Component specification Hdmi output with DVD-Audio sourcesExample Format VSX-72TXVAdditional information About the i.LINK output settings Connections Setup Bitstream*1Mpeg Sacd Playback Ch AreaAdditional information Language code list Country/Area code listLanguage Language code letter, Language code Country/Area, Country/Area code, Country/Area code letterGlossary Dynamic range File extensionLink Interlaced videoPqls Precision Quartz Lock System rate control Progressive scan videoSampling frequency Slideshow DVD, Video CDAdditional information Troubleshooting ProblemGeneral Disc won’t play or is automatically ejected after loadingProblem Remedy DVD/CD/Video CD/ playerProblemRemedy Check that Linear PCM Out is set to Down Sample Off Right or sounds incompleteDialog Effectiveness of TruSurround varies with the discHdmi troubleshooting Bandwidth Digital Content Protection HdcpIsn’t damaged Be made with components compatible with both DVI and HighOn page 71 to change the Hdmi resolution Make sure the resolution on this player matches thatComponent you have connected using HDMI. See Hdmi Settings Link troubleshooting Output Mode is set to 5.1 Channel see Audio Output Mode onLINK-related messages Link CheckAdditional information Specifications Pioneer Electronics USA INC Pioneer Electronics of CANADA, INCPioneer Europe NV Pioneer Electronics DE Mexico S.A. DE C.V