Connecting up
Chapter 2
Connecting up
Easy connections
The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In this setup, stereo audio is played through the speakers in your TV.
TV |
DIGITAL AUDIO OUT | AUDIO OUT |
|
Y | PB |
|
COAXIAL | L | AV CONNECTOR (RGB) - TV/AV Receiver |
|
|
| R |
S |
| PR |
VIDEO OUT | COMPONENT VIDEO OUT |
| White | |
Yellow | Red |
Important
Connecting using a SCART AV cable
A
The SCART AV connector also outputs analog audio, so there is no need to also connect the AUDIO OUT L/R jacks.
SCART |
TV |
DIGITAL AUDIO OUT | AUDIO OUT |
|
Y | PB |
|
COAXIAL | L | AV CONNECTOR (RGB) - TV/AV Receiver |
|
|
| R |
S |
| PR |
VIDEO OUT | COMPONENT VIDEO OUT |
1Use a SCART cable (not supplied) to connect the AV CONNECTOR (RGB) output to a SCART AV input on your TV (or AV receiver).
Connecting using the S-video output
1 Connect the VIDEO OUT and AUDIO OUT L/R jacks to a set ofA/V inputs on your TV.
• This player is equipped with copy protection technology. Do not connect this player to your TV
via a VCR using audio/video or
• When connecting to your TV as shown above, do not set the Component Out setting (see Video | |
Output settings on page 18) to Progressive. |
Use the supplied audio/video cable, connecting the red and white plugs to the audio outputs and the yellow plug to the video output. Make sure you match up the left and right audio outputs with their corresponding inputs for correct stereo sound.
See below if you want to use a component or
•
2 Connect the supplied AC power cable to the AC IN inlet, then plug into a power outlet.
If your TV (or other equipment) has an
•Use an
Line up the small triangle above the jack with the same mark on the plug before plugging in.
IN
TV
DIGITAL AUDIO OUT | AUDIO OUT |
Y | PB |
COAXIAL | L |
| R |
S VIDEO OUT | PR |
COMPONENT VIDEO OUT |
Note
•Before unplugging the player from the power outlet, make sure you first switch it into standby using either the front panel STANDBY/ON button, or the remote control, and wait of the
•For the above reasons, do not plug this player into a switched power supply found on some
amplifiers and AV receivers.
Connecting using the component video output | English |
video output available. | |
You can use the component video output instead of the standard video out jack to connect this player |
|
to your TV (or other equipment). This should give you the best quality picture from the three types of |
|
|
|
| 7 |
| En |