| Section |
Using iPod | 12 |
|
|
Basic Operations
1 2 3 4
5
!You can use this unit to control an iPod by using a cable (e.g.,
!If an iPod with video capabilities is con- nected to this unit via interface cable (e.g.
1Source icon
Shows which source has been selected.
2Repeat indicator
Shows when repeat range is set to or .
3Song number indicator
Up to 65 535 can be displayed as the song number.
4Shuffle indicator
Shows when random play is set to Songs or Albums.
5Song information
Shows detailed information of currently playing song.
1 Touch the source icon and then touch iPod to select the iPod.
While connected to this unit, PIONEER, Acces- sory Attached or (check mark) is displayed on the iPod.
#When the source icon is not displayed, you can display it by touching the screen.
#Touch Hide to hide the touch panel keys.
#Before connecting the dock connector of this unit to the iPod, disconnect the headphones from the iPod.
#Depending on the model of iPod or the data size in the iPod, there may be a delay to start play- ing after connection.
#After the iPod has been connected to this unit, use touch panel keys to select the iPod.
#When removing the iPod from this unit, this unit is turned off.
2To skip back or forward to another
song/video, touch oor p.
# You can also skip back or forward to another song/video by pressing cor d(TRK).
3To perform fast forward or reverse, keep touching oor p.
When video is playing, if you keep touching oor p for five seconds, the icon mor n is highlighted. When this happens, fast reverse/fast forward continues even if you re- lease oor p. To resume playback at a de-
sired point, touch f.
# You can also perform fast reverse/fast forward by pressing and holding cor d(TRK).
4When playing a file with chapter, touch oor pto select a chapter.
Notes
!Read the precautions for iPod in the following section. Refer to page 105.
!If an error message or icon is displayed, refer to Error messages on page 97.
!Connect directly the dock connector cable to the iPod so that this unit works properly.
!When the ignition switch is set to ACC or ON, the iPod’s battery is charged while the iPod is connected to this unit.
!While the iPod is connected to this unit, the iPod cannot be turned on or off.
!The iPod is turned off about two minutes after the ignition switch is set to OFF.
!If specific information is not recorded on the iPod, No xxxx will be displayed (e.g.,
No Name).
Using iPod
En 39