Section
19Available accessories
Front (front
#You can switch to Phase only when the sub- woofer has been set to On.
3Touch c or d to select the correct size for the selected speaker.
Each time you touch cor d selects the size in the following order:
Off
# You cannot select Off, when Front (front
speakers) have been selected.
# You can select On or Off, when Subwoofer
(subwoofer) has been selected.
# You can switch Reverse (reverse phase) or Normal (normal phase), when Phase (subwoofer setting) has been selected.
Note
When playing a
!No audio is outputted if the center speaker setting is Small or Large and no center speak- er is installed.
!Audio is heard only over the center speaker if installed and the center speaker setting is Small or Large.
Adjusting the speaker output levels
Speaker level can be adjusted finely by listen- ing to an audio output. First, use test tone to adjust the approximate speaker level, and then use this function to adjust finely.
Correcting the subwoofer’s phase
If trying to boost the bass output of the sub- woofer doesn’t do much or rather makes you feel that the bass gets more murky, this may indicate that the subwoofer’s output and bass content you hear over other speakers cancel each other out. To remove this problem, try changing the phase setting for the subwoofer.
1Touch Speaker Setting.
2Touch a or b to select Subwoofer (sub- woofer).
Each time you touch aor b selects the speak- er in the following order:
Front (front
3Touch d to turn subwoofer output on.
# To turn subwoofer output off, touch c.
4Touch b and then touch c or d to se- lect the phase of subwoofer output. Touch d to select normal phase and Normal appears in the display. Touch c to select re- verse phase and Reverse appears in the dis- play.
1Touch Speaker Level.
2Touch a or b to select the speaker to be adjusted.
Each time you touch aor b selects the speak- er in the following order:
speaker
# You cannot select speakers whose size is set to Off. (Refer to Setting the speaker setting on the previous page.)
3Touch c or d to adjust the speaker out- put level.
Each time you touch cor d it increases or de- creases the equalizer level. +10 to
Note
To adjust the speaker output levels in this mode is the same as making the speaker output levels at Test Tone. Both provide the same results.
88 En