Toshiba MW27H62 owner manual Important Safeguards

Page 4

Introduction

 

IMPORTANT SAFEGUARDS

S

 

 

 

 

 

 

 

 

 

 

25)Always operate this equipment from a 120 V AC, 60 Hz power source only.

26)Always make sure the antenna system is properly grounded to provide adequate protection against voltage surges and built-up static charges (see Section 810 of the National Electric Code).

31) [This item applies to projection TVs only.] If the air

temperature rises suddenly (for example, when the TV is

first delivered), condensation may form on the lenses.

This can make the picture appear distorted or the color

appear faded. If this happens, turn off the TV for 6 to 7

hours to allow the condensation to evaporate.

32) For added protection of your TV from lightning and

power surges, always unplug the power cord and

disconnect the antenna from the TV if you leave the TV

unattended or unused for long periods of time.

Ground clamp

Electric service equipment

Ground clamps

Antenna lead-in wire

Antenna discharge unit (NEC Section 810-20)

Grounding conductors (NEC Section 810-21)

Power service grounding

electrode system (NEC Art 250 Part H)

33) During normal use, the TV may make

occasional snapping or popping

sounds. This is normal, especially

when the unit is being turned on or

off. If these sounds become frequent

or continuous, unplug the power cord

and contact a Toshiba Authorized Service Center.

34) Possible Adverse Effects on TV Picture Display: If a

fixed (non-moving) pattern or image remains on the TV

screen for extended periods of time, the image can

become permanently ingrained in the cathode ray

27)DANGER: RISK OF SERIOUS PERSONAL INJURY OR DEATH!

• Use extreme care to make sure you are never in a position where your body (or any item you are in contact with, such as a ladder or screwdriver) can accidentally touch overhead power lines. Never locate the antenna near overhead power lines or other electrical circuits.

Never attempt to install any of the following during lightning activity:

a) an antenna system; or b) cables, wires, or any home theater component connected to an antenna or phone system.

Care

For better performance and safer operation of your TOSHIBA TV, follow these recommendations and precautions:

28)Always sit approximately 10Ð25 feet away from the TV and as directly in front of it as possible. The picture can appear dull if you sit too far to the left or right of the TV, or if sunlight or room lights reflect on the screen. Turn the TV off to check for reflections on the screen, and then remove the source of reflections while viewing the TV.

29)Always unplug the TV before cleaning. Never use liquid or aerosol cleaners.

30)WARNING: RISK OF ELECTRIC SHOCK! Never spill liquids or push objects of any kind into the TV cabinet slots.

4

tube(s) of the TV and cause subtle but permanent ghost

images. This type of damage is NOT COVERED BY

YOUR WARRANTY. Never leave the TV on for extended

periods of time while it is displaying the following images

or formats:

• Fixed Images, including but not limited to PIP/POP

windows, closed captions, video game patterns, TV

station logos, stock tickers, and websites.

• Special Formats that do not use the entire screen,

including but not limited to widescreen or letterbox

format media viewed on a 4:3 aspect ratio display

(with gray or black bars at the top and bottom of the

screen); or 4:3 aspect ratio format media viewed on a

widescreen/16:9 aspect ratio display (with gray or

black bars on the left and right sides of the screen).

Service

35)WARNING: RISK OF ELECTRIC SHOCK! Never attempt to service the TV yourself. Opening and

removing the covers may expose you to dangerous voltage or other hazards. Refer all servicing to a

QUALIFIED

Toshiba Authorized Service Center.SERVICE

TECHNICIAN

36)If you have the TV serviced:

Ask the service technician to use only replacement parts specified by the manufacturer.

Upon completion of service, ask the service technician to perform routine safety checks to determine that the TV is in safe operating condition.

37)When the TV reaches the end of its useful life, ask a qualified service technician to properly dispose of the TV. Improper disposal may result in a picture tube implosion and possible personal injury.

0303

5V60101A [E]p02-05

4

2/22/06, 1:02 PM

Image 4
Contents MW27H62 Dear Customer IntroductionImportant Safeguards IntroductionImportant Safeguards Power source MAY be Present When the Enclosure is OPENED. doLocation of the required Marking This Digital Video Player Employs a Laser SystemDo not use the unit when moisture condensation may occur PrecautionsMoisture condensation occurs during the following cases Contents On cleaning discs Structure of disc contentsOn handling discs On storing discsPlayable discs USB Port InformationDVD Identification of controls Front panelRear panel See the page in for detailsRemote control DVD Menu buttonInserting batteries OperationAntenna connections ConnectionsConnections AntennaCable TV connections ConverterDescrambler Converter DescramblerConnecting to a camcorder Connecting to optional equipmentInput Connecting to an amplifier equipped with a DTS decoder Dolby DigitalDolby Surround Pro Logic Digital Theater Systems DTSMPEG2 sound Channel digital stereoConnecting to a USB Storage Device Connecting to a USB Storage DeviceStarting setup Starting setupBasic setup PowerAuto clock setting To set auto clock to OFF Clock settingAuto clock adjustment TV/VCR Power Display Enter Menu To set standard timePress MENU, then press or To select Option Press or to select your time zone, then Press EnterManual clock setting Enter MenuTo make corrections anytime during the process Press or To set the month, then pressSetting the language TV/VCR operation statusDisplay Enter Menu While watching TVTV operation TV operationTV operation Channel UP/DOWN Channel ReturnMute SleepTo view closed captions analog mode Closed captionsClosed captions Enter Menu Closed CaptionThen press Press Option Press To select Digital Setup Then pressCaption mode, then press Enter TV/CABLE selection Automatic memory tuning To memorize channelsPress Or to select ADD/ERASE, then Press Menu in the analog mode, then pressTo add a digital channel you are watching Setting the V-Chip To register password To change passwordButtons 0-9 for safety, then press Enter Buttons 0-9, then press EnterDisplay Enter Cancel Menu To set the V-ChipTo set the on timer To set the on timerNow the on Timer is set Enter Menu ProgramTo set the off timer To set the off timerMenu Program Picture control adjustment Adjusting the picture preference Picture control adjustmentAdjusting the picture preference Mode Picture qualitySelecting the color temperature Selecting the color temperatureCancel Menu ModeViewing the wide-screen picture formats Viewing the wide-screen picture formatsPIC Size ZoomSound control adjustment Setting the StableSoundSetting the surround sound Press Cancel while making sound adjustmentsSetting the SAP analog mode Stereo and Second Audio Program SAPListening to stereo sound Listening to SAP Second Audio ProgramSetting the digital setup digital mode Press Menu in the digital mode, then pressFollow the left steps Press or To select Digital Output Then press Or to select PCM or DolbyLoading and unloading a cassette tape LoadingUnloading To prevent accidental erasureCassette tape playback PlaybackRewind or forward the tape TV/VCRSpecial playback Display Menu Play Counter Reset REC Repeat playback Using the real time tape counterConvenient function Zero return function Video head cleaning Display Zero Return Stop Play REC Counter ResetVideo head cleaning Video head cloggingRecording a TV program Recording a TV programTo stop recording To stop recording temporarilyOne-touch timer recording OTR To cancel OTRDVD Stop REC SpeedTimer recording Timer recordingTV/VCR Enter Menu Timer REC To set daily/weekly timer To confirm the settingsTo cancel a program Enter Cancel ProgramDuplicating a video tape Duplicating a video tapeOther functions VCR VCRRecording a DVD/CD disc Duplicating a DVD or CD discDVD TV/VCR Play Stop REC SpeedVcdcd Basic playback Playing a discBasic playback DVD To obtain a higher quality picture PlayAbout Playing in fast reverse or fast forward directions Vcddvd Playing frame by frameVcddvd Playing in slow-motion VCD Locating a chapter or trackJump Enter Cancel Zoom Zooming/Locating desired sceneZooming VCD Locating desired scenePlay Mode Enter Repeat playback/A-B Repeat playbackVcddvd Repeat playback VCD A-B Repeat playbackPlay Mode Cancel Play Enter Program playback/Random playbackVCD Program playback VCD Random playbackChanging angles/Title selection/DVD menu Changing anglesTitle selection DVD menuChanging soundtrack language/ Subtitles Changing soundtrack language SubtitlesSubtitle Audio Select Audio SelectPlay Mode Disc status/To turn off the PBCVcddvd Disc status VCD To turn off the PBCMP3/WMA/JPEG/DivX and Audio CD operation CD MP3/WMA/JPEG/DivX data informationLimitations on MP3/WMA/JPEG/DivX playback Limitations on displaying of the file nameLoading media ReturnDVD/USB Press Stop to end playbackCD operation Jpeg playbackSlide show playback DVD MenuPlaying DivX VOD content DivX playbackEnter Play Skip Select Mode Off in stepRandom playback will start Enter Play Advanced playback DVDCustomizing the function settings Setting procedureFunction setup DVD Setup ReturnSetting details Menu, Subtitle, Audio English, Francais, EspanolOther Original AudioPicture Mode Jpeg IntervalOff SecondsIf you forget the password Parental control settingDivX VOD Temporary cancel the rating level by DVD disc Temporary cancel the rating level by DVD discEnter Play Return OPEN/CLOSE Language code list OthersReception disturbances OthersTroubleshooting Symptoms Cause Possible Solutions PowerSymptoms Cause Possible Solutions VCR Specifications Supplied accessoriesGeneral Input/OutputLimited United States Warranty Limited Ninety 90 Day Warranty on LaborLimited Warranty for Commercial Units Your ResponsibilityHow to Obtain Warranty Service For additional information, visit TACP’s websiteMemo J5V60101A SH 06/02 N