Toshiba MW27H62 owner manual Power source, Location of the required Marking, Not Stare Into Beam

Page 5

SAFETY PRECAUTION/ Power source

WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the distance between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance with the FCC (Federal Communications Commission) Rules could void the user's authority to operate this equipment.

CAUTION:

Location of the required Marking

The rating sheet and the safety caution

THIS DIGITAL VIDEO PLAYER EMPLOYS A LASER SYSTEM.

are on the rear of the unit.

 

TO ENSURE PROPER USE OF THIS PRODUCT, PLEASE READ

 

THIS OWNER'S MANUAL CAREFULLY AND RETAIN FOR FU-

 

TURE REFERENCE. SHOULD THE UNIT REQUIRE MAINTE-

 

NANCE, CONTACT AN AUTHORIZED SERVICE LOCATION.

 

USE OF CONTROLS, ADJUSTMENTS OR THE PERFORMANCE

 

OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN

 

MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

 

TO PREVENT DIRECT EXPOSURE TO LASER BEAM, DO NOT

 

TRY TO OPEN THE ENCLOSURE. VISIBLE LASER RADIATION

CERTIFICATION: COMPLIES WITH

MAY BE PRESENT WHEN THE ENCLOSURE IS OPENED. DO

FDA RADIATION PERFORMANCE

NOT STARE INTO BEAM.

STANDARDS, 21 CFR SUBCHAPTER J.

 

WARNING: This product contains a laser beam. Do not attempt to stare at the beam through the DVD disc tray or the ventilation openings. Staring directly at the beam may cause permanent damage to your eyesight.

Introduction

IMPORTANT RECYCLING INFORMATION

This product uses both Cathode Ray Tube (CRT) and other components that contain lead. In your community there might be regulations that require you to dispose these materials

properly under environmental considerations. Please contact your local authorities, or the Electronic Industries Alliance (http://www.eiae.org) for disposal or recycling information.

Power source

AC Outlet

Wider Hole

and Blade

Polarized AC Cord Plug

(One blade is wider than the other.)

TO USE AC POWER SOURCE

Use the AC polarized line cord provided for operation on AC. Insert the AC cord plug into a standard 120V 60Hz polarized AC outlet.

Notes:

Never connect the AC line cord plug to other than the specified voltage (120V 60Hz). Use the attached power cord only.

If the polarized AC cord does not fit into a non-polarized AC outlet, do not attempt to file or cut the blade. It is the user’s responsibility to have an electrician replace the obsolete outlet.

If you cause a static discharge when touching the unit and the unit fails to function, simply unplug the unit from the AC outlet and plug it back in. The unit should return to normal operation.

If the AC cord plug is plugged in for the first time, wait for approx. 5 seconds before pressing the POWER button.

5

5V60101A [E]p02-05

5

2/22/06, 1:02 PM

Image 5
Contents MW27H62 Introduction Dear CustomerIntroduction Important SafeguardsImportant Safeguards MAY be Present When the Enclosure is OPENED. do Power sourceLocation of the required Marking This Digital Video Player Employs a Laser SystemMoisture condensation occurs during the following cases PrecautionsDo not use the unit when moisture condensation may occur Contents Structure of disc contents On cleaning discsOn handling discs On storing discsDVD USB Port InformationPlayable discs Front panel Identification of controlsRear panel See the page in for detailsDVD Menu button Remote controlOperation Inserting batteriesConnections Antenna connectionsConnections AntennaConverter Cable TV connectionsDescrambler Converter DescramblerInput Connecting to optional equipmentConnecting to a camcorder Dolby Digital Connecting to an amplifier equipped with a DTS decoderDolby Surround Pro Logic Digital Theater Systems DTSChannel digital stereo MPEG2 soundConnecting to a USB Storage Device Connecting to a USB Storage DeviceStarting setup Starting setupBasic setup PowerAuto clock adjustment Clock settingAuto clock setting To set auto clock to OFF To set standard time TV/VCR Power Display Enter MenuPress MENU, then press or To select Option Press or to select your time zone, then Press EnterEnter Menu Manual clock settingTo make corrections anytime during the process Press or To set the month, then pressTV/VCR operation status Setting the languageDisplay Enter Menu While watching TVTV operation TV operationTV operation Channel Return Channel UP/DOWNMute SleepClosed captions To view closed captions analog modeClosed captions Enter Menu Closed CaptionCaption mode, then press Enter Option Press To select Digital Setup Then pressThen press Press To memorize channels TV/CABLE selection Automatic memory tuningTo add a digital channel you are watching Press Menu in the analog mode, then pressPress Or to select ADD/ERASE, then To register password To change password Setting the V-ChipButtons 0-9 for safety, then press Enter Buttons 0-9, then press EnterTo set the V-Chip Display Enter Cancel MenuTo set the on timer To set the on timerNow the on Timer is set Enter Menu ProgramMenu Program To set the off timerTo set the off timer Picture control adjustment Picture control adjustment Adjusting the picture preferenceAdjusting the picture preference Mode Picture qualitySelecting the color temperature Selecting the color temperatureCancel Menu ModeViewing the wide-screen picture formats Viewing the wide-screen picture formatsPIC Size ZoomSetting the StableSound Sound control adjustmentSetting the surround sound Press Cancel while making sound adjustmentsStereo and Second Audio Program SAP Setting the SAP analog modeListening to stereo sound Listening to SAP Second Audio ProgramPress Menu in the digital mode, then press Setting the digital setup digital modeFollow the left steps Press or To select Digital Output Then press Or to select PCM or DolbyLoading Loading and unloading a cassette tapeUnloading To prevent accidental erasurePlayback Cassette tape playbackRewind or forward the tape TV/VCRSpecial playback Convenient function Repeat playback Using the real time tape counterDisplay Menu Play Counter Reset REC Display Zero Return Stop Play REC Counter Reset Zero return function Video head cleaningVideo head cleaning Video head cloggingRecording a TV program Recording a TV programTo stop recording To stop recording temporarilyTo cancel OTR One-touch timer recording OTRDVD Stop REC SpeedTV/VCR Enter Menu Timer REC Timer recordingTimer recording To confirm the settings To set daily/weekly timerTo cancel a program Enter Cancel ProgramDuplicating a video tape Duplicating a video tapeOther functions VCR VCRDuplicating a DVD or CD disc Recording a DVD/CD discDVD TV/VCR Play Stop REC SpeedBasic playback DVD Playing a discVcdcd Basic playback About PlayTo obtain a higher quality picture Vcddvd Playing frame by frame Playing in fast reverse or fast forward directionsVcddvd Playing in slow-motion VCD Locating a chapter or trackZooming/Locating desired scene Jump Enter Cancel ZoomZooming VCD Locating desired sceneRepeat playback/A-B Repeat playback Play Mode EnterVcddvd Repeat playback VCD A-B Repeat playbackProgram playback/Random playback Play Mode Cancel Play EnterVCD Program playback VCD Random playbackChanging angles Changing angles/Title selection/DVD menuTitle selection DVD menuChanging soundtrack language Subtitles Changing soundtrack language/ SubtitlesSubtitle Audio Select Audio SelectDisc status/To turn off the PBC Play ModeVcddvd Disc status VCD To turn off the PBCCD MP3/WMA/JPEG/DivX data information MP3/WMA/JPEG/DivX and Audio CD operationLimitations on MP3/WMA/JPEG/DivX playback Limitations on displaying of the file nameReturn Loading mediaDVD/USB Press Stop to end playbackJpeg playback CD operationSlide show playback DVD MenuDivX playback Playing DivX VOD contentRandom playback will start Select Mode Off in stepEnter Play Skip Advanced playback DVD Enter PlaySetting procedure Customizing the function settingsFunction setup DVD Setup ReturnSetting details English, Francais, Espanol Menu, Subtitle, AudioOther Original AudioJpeg Interval Picture ModeOff SecondsDivX VOD Parental control settingIf you forget the password Enter Play Return OPEN/CLOSE Temporary cancel the rating level by DVD discTemporary cancel the rating level by DVD disc Others Language code listOthers Reception disturbancesSymptoms Cause Possible Solutions Power TroubleshootingSymptoms Cause Possible Solutions VCR Supplied accessories SpecificationsGeneral Input/OutputLimited Ninety 90 Day Warranty on Labor Limited United States WarrantyLimited Warranty for Commercial Units Your ResponsibilityFor additional information, visit TACP’s website How to Obtain Warranty ServiceMemo J5V60101A SH 06/02 N