VOD715
TO
FACTORY
RADIO
|
| Hard Wired FM Modulator Output |
|
| 12 VDC Power and Ground |
| Satalite |
|
Am/Fm | Radio | FM |
Antenna |
| |
|
| Modulator |
Dash Radio |
| |
|
| Second IR |
|
| Input |
| CHOKE |
|
14Pin FMM Cable
Item #8
Battery 12V
Power Harness
Item #3
To Secondary AV Monitor
12 VDC Power and Ground | INPUT |
|
|
| |
VIDEO |
|
| TO |
| |
|
|
|
| ||
|
|
| LINE | OPTIONAL | Line |
Auxillary |
|
| OUT | ADDITIONAL |
|
| Patch Cord | MONITOR |
| ||
video display |
| VIDEO |
|
| |
| RCA Male to Male |
| Line | ||
|
|
| (Yellow) |
| Line |
|
|
|
|
| |
| Optional Remote Headphone Stations |
|
|
| |
| Green |
| Stereo |
|
|
| (Right+) |
| Headphone Jack |
| |
| Black |
| Stereo |
|
|
| (Ground) |
| Headphone Jack | Dome Light | |
| Gray |
|
|
| Power Source |
|
|
|
|
| |
| (Left+) |
|
|
|
|
Power Connector | "Y" Adapter |
4 Pin | for use with |
Clean the IR Receiver Window on the front of the VCP. | |
Remove Adhesive Backing and Apply IR LED to IR | Installations |
Item# 5 |
Power Harness
Item #3
Accessory
Harness - Optional
(P/N:8010730)
Red RCA (Audio Right)
White RCA (Audio Left)
Yellow RCA (Video)
OPTIONAL
Figure A
1)Make the connections to the vehicle for the 12 pin wiring harness and battery wire.
2)Insert the Circular
3)Pull the wire tie loop tight and cut off the excess.
4)Connect the 12 pin harness to the mating connector on the Video Monitor.
5)Connect the wired headphone to the remote headphone jacks to the video monitor if those options are being included.
6)Connect the 14 Pin wire to the FM modulator.
7)Connect power harness to vehicle’s electrical system by tapping into an accessory hot line.
8)Verify all functions of the System before final mounting of the finished assembly.
Note: A VCP or other A/V Component can be connected to the video monitor system using a second
source component harness (purchased separately, part number: 8010730). This harness would plug into the
A/V Source Definitions:
1= VCP or VCP with TV Tuner
3=