GE JK95527 Using the self-cleaning oven, and Cleaning Troubleshooting, Before a Clean Cycle

Using the self-cleaning oven. ge.com

The oven door must be closed and all controls must be set correctly for the cycle to work properly.

Safety

Wipe up heavy soil on the oven bottom. (appearance may vary)

Before a Clean Cycle

We recommend venting your kitchen with an open window or using a ventilation fan or hood during

the first self-clean cycle.

Remove the broiler pan, broiler grid, probe, all cookware and any aluminum foil from the oven.

The oven racks and convection roasting rack can be self-cleaned, but they will darken, lose their luster and become hard to slide.

Do not use abrasives or oven cleaners. Clean the top, sides and outside of the oven door with soap and water.

Make sure the oven light bulb cover (on some models) is in place and the oven light is off.

IMPORTANT: The health of some birds is extremely sensitive to the fumes given off during the self-cleaning cycle of any oven. Move birds to another well-ventilated room.

■On double oven models, you can set a clean cycle in both ovens at the same time. The last oven set will automatically delay its start until the end of the first oven’s clean cycle.

■On double oven models, you can use timed baking in one oven and self-clean the other at the same time.

Instructions Operating Instructions Care

How to Set the Oven for Cleaning

Press the SELF CLEAN STD/LOW pad once for a 4-hour clean time or twice for a 3-hour clean time.

A 3-hour self-clean time is recommended for use when cleaning small, contained spills. A self-clean time of 4 hours or longer is recommended for a dirtier oven.

If a time other than 4 hours or

3 hours is needed, use the number pads and enter the desired clean time.

You can change the clean time to any time between 3 hours and 5 hours, depending on how dirty your oven is.

When the LOCKED light goes off, you will be able to open the door.

■The word LOCKED will flash and the oven control will signal if you set the clean cycle and forget to close the oven door.

■To stop a clean cycle, press the

CLEAR/OFF pad. When the LOCKED light goes off indicating the oven has cooled below the locking temperature, you will be able to open the door.

and Cleaning Troubleshooting

Press the START pad.

The door locks automatically. The display will show the clean time remaining. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED light goes off.

21

Tips Consumer Support