2.LINE OUT
This is a standard 1/8 stereo jack that provides a fixed low level output.
3.DC 12V OUTPUT
You can connect this jack to an Audiovox
4.AUDIO R INPUT 1, AUDIO L INPUT 1, VIDEO INPUT 1 AUDIO R INPUT 2, AUDIO L INPUT 2, VIDEO INPUT 2
For input of an external A/V source such as video game, camcorder, digital camera etc. Always match the
5.EXTERNAL TV ANTENNA JACK
You can input your CATV into this jack for receiving CATV stations.
F. TV Operation
1.Press TV/AV1/AV2 to select the TV mode or AV1/AV2.
2.Press TV/CATV to select the type of signal you receive, When using an antenna, adjust it to its best extension, angulation and direction to optimize the image and sound. When using cable, connect the cable to the external antenna jack, and press TV/CATV on the remote control to select STD, HRC or IRC (see Remote Control section). STD is used by most cable systems, however, if the STD setting does not work with your TV, try the other settings and/or check with your cable service provider.
3.Pressing AUTO PROG, the TV’s tuner will scan the entire range of the se- lected band and memorize all the active channels in your area.
4.Press TV CHANNEL UP/DOWN or use the number buttons for TV to select any active channel.
5.Press VOLUME UP/DOWN to raise or lower the sound level.
6.If the picture needs to be adjusted, press PICTURE to illuminate the on- screen display for contrast, brightness, color and tint in sequence, and press +/- to adjust each function up/down.
7.Press MUTE to cut off the sound, and the screen will display the volume adjustment bar for six seconds to indicate that the sound has been turned off. Press MUTE again to restore sound to the sound level set previously. You can also release the mute feature by pressing VOLUME UP/DOWN.
5