J. Battery Installation
a.Turn the Remote Control face down. Press the ridged area of the battery cover and slide it off in the same direction as the arrow.
b.Install two AAA batteries. Make sure that proper polarity
c.Slide back the cover in the contrary direction as the arrow until it clicks.
a. |
|
|
|
| b. |
|
|
| c. | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
K. CHANNEL TUNING SET UP
In addition to normal broadcast reception of VHF and UHF channels, if you are a Cable TV subscriber, your new TV is capable of receiving many unscrambled Cable channels without the use of a converter box. When set to Broadcast TV it receives
1.Use the TV/CATV button on the Remote Control to select the broadcast or cable system appropriate for your home. The system selected will be displayed on the screen. If you have an external roof mounted or rabbit ear antenna, select “TV,” if you have CABLE TV, select either “STD”, “HRC” or IRC (“STD” is used by the majority of Cable Systems. Check with your cable system operator).
2.Press the AUTO MEMORY button on the Remote Control Unit or the TV. You will see the TV cycle through all channels. The
3.To view only strong clear channels, press the SKIP/SEARCH button on the Remote Control Unit until “SKIP MODE ON” is displayed on the bottom of the screen. The TV will now tune only to strong, active channels, when the UP or DOWN buttons are used on the monitor or remote control.
To view a weak or marginal channel, press the SKIP/SEARCH button on the Remote Control Unit until “SKIP MODE OFF” is displayed on the bottom of the screen. Tune to the desired channel using the CHANNEL UP/DOWN button or go directly to the channel by direct access using the
4.To ERASE a channel, press the ERASE/WRITE button on the Remote Control Unit until “MANUAL MEMORY XX ERASE” is displayed on screen. To STORE a channel, press the button until “MANUAL MEMORY XX ADD” is displayed on screen.
9