Apex Digital AD-703A Connecting to an Audio System or TV Component Video Input, Best Picture

Connecting to an Audio System or TV Component Video Input

BEST PICTURE

The Component Video input allows you to enjoy the sound and picture quality of the DVD video discs.

• How to setup the sound output

From the SETUP MENU, set the "AUDIO OUTPUT" To "ANALOG".

• How to setup the video output

From the SETUP MENU, set the "SET VIDEO OUT" to "YUV VIDEO" when using the Component Video output jacks.

1

2

To Cb VIDEO IN

To Cr VIDEO IN

To Y VIDEO IN

NOTICE

•It will be helpful to also refer to the manual of the connected TV.

•Turn off the power and unplug both units before setting up any connections.

•Keep the DVD video player away from any tuner or radio to avoid any static or distorted sound during a broadcast.

•When connecting any disconnecting the DVD video player, be sure to turn off the amplifier to avoid any speaker damage.

•Due to the wide dynamic range of sound output of the DVD video player, adjust the volume of your receiver to a comfortably modist listening level to avoid any speaker damage.

NOTICE (COMPONENT VIDEO OUTPUT)

Component input terminals when connected to selected TVs and monitors will produce a higher quality picture playback. Depending on the selected TVs and monitors, the wording of the component input terminals may vary. (ie:R-Y, Y, B-Y, etc.) If there are any fluctuations with the color played back adjust the TV or monitor to achieve the best audio and/or picture.