Apex Digital AD-703A warranty Before Calling Service Personnel, Symptom Cause Correction

Before Calling Service Personnel

			Check the following guide for the possible cause of a problem
			before contacting service.
SYMPTOMS AND CORRECTION
	Symptom	Cause		Correction
	No power	• The power plug is disconnected		• Connect the power plug into the wall outlet securely.
	No picture	• The TV is not set to receive DVD output		• Select the appropriate video input mode on the TV so the
				picture from the DVD video player appears on the TV
				screen.
		• The video cable is not connected securely		• Connect the video cable into the jacks securely.
	No sound	• The equipment connected with the audio		• Select the correct input mode of the audio receiver so you
		cable is not set to receive DVD signal output.		can listen to the sound from the DVD video player.
		• The audio cables are not connected		• Connect the audio cable into the jacks securely.
		securely.
		• The power of the equipment connected		• Turn on the equipment connected with the audio cable.
		with the audio cable is turned off.
		• The setting of output sound type is		• Set the audio setting correctly.
		not correct.
	The playback	• The disc is dirty.		• Eject the disc and clean it.
	picture has
	occasional distortion	• It is in fast forward reverse playback.		• Sometimes a small amount of picture distortion may
				appear. This is not malfunction.
	Brightness is unstable	• The copy protection’s effect.		• Connect the DVD video player to the TV directly.
	or noises are produced
	on playback pictures
	The DVD video player	• No disc is inserted.		• Insert a disc. (Check that the DVD or VCD or audio CD
	does not start playback			indicator in the DVD displays is lit.)
		• An unplayable disc is inserted.		• Insert a playback disc. (Check the disc type and color
				system).
		• The disc is placed upside down.		• Place the disc with the playback side down.
		• The disc is not placed within the guide.		• Place the disc on the disc tray correctly inside the guide.
		• The disc is dirty.		• Clean the disc.
		• A menu is on the TV screen.		• Press the SETUP button to turn off the menu screen.
		• The parental lock function is set.		• Cancel the parental lock function or change the parental
				lock level. (The Pre-set password is 3308.)
	Buttons do not work	• Power supply fluctuations or other		• Turn the power on or off with the POWER button. Or
		abnormalities such as static electricity may		disconnect the power plug and insert it into the wall outlet
		interrupt correct operations.		again.
				• Check each button on the remote, make sure it is in
				normal position.
	The remote control	•The remote control is not pointed at the		• Point the remote control at the remote sensor of the DVD
	does not work properly	remote sensor of the DVD video player.		video player (left side).
		•The remote control is too far from the DVD		• Operate the remote control within about 7m.
		video player.
		•The batteries in the remote control are		• Replace the batteries with new ones.
		exhausted.

38 A P E X D I G I T A L AD-703A