Apex Digital AD-703A warranty Preparing the Remote Control, Operating with the Remote Control

Remote Control

Continued

PREPARING THE REMOTE CONTROL

To operate the DVD video player, you must first place the batteries in the remote control.

1 2 3

Open the cover.	Insert batteries (AAA size).	Close the cover.
	Make sure to match the + and - on
	the batteries to the marks inside the
	battery compartment.

OPERATING WITH THE REMOTE CONTROL

Operating DVD video player with the remote control.

1

				1	2	3	4	5	6	7	8	9	0	+10
			AD-703
														3 DISC
	MIC LEVEL
_	+	_	+
1		MIC	2
			30˚	30˚

The remote control must point at the remote sensor, in order for the DVD player to function correctly.

Distance: Maximum of 7 m from the front of the remote sensor.

Angle: Approximately 30˚ from each direction.

*Please do not place the remote sensor towards any light source such as direct sunlight or illumination. The DVD video player will malfunction, if you do so.

NOTICE (BATTERIES)

FOLLOW INSTRUCTIONS BELOW BECAUSE INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK OR CORRODE.

•Do not place the batteries in the wrong direction.

•It is dangerous to charge/heat/open or short-circuit the batteries.

•Do not leave dead batteries or mix old/new batteries in the remote control.

•When not using the remote control for a long duration of time, remove the batteries.

•When difficulties occur, with the remote control, or if the operating range becomes reduced, then replace the batteries.

•If leakage from the battery occurs, wipe the battery liquid from the battery compartment, then replace the batteries.

•With normal usage the batteries should last one year.

NOTICE (REMOTE CONTROL)

•The remote control should be aimed directly towards the remote sensor of the DVD video player.

•Avoid dropping the remote control.

•Avoid spilling any liquids and/or extreme heat.

AD-703A A P E X D I G I T A L 10