Other functions

Operating the radio

The receiver has a built-in tuner that allows for AM/FM radio function.

POWER

SOURCE

SKIP/TUNING +/-

Manual tuning

1.Connect the FM and AM antenna accordingly see “Connecting the Antenna” on page 12 section for details

2.Press the POWER button to switch on the receiver.

3.Press the SOURCE button to enter TUNER mode.

4.To select band, press the SOURCE button to toggle between AM/FM modes.

5. Tune the stations by pressing the TUNE or TUNE buttons repeatedly until the desired station is found.

NOTE: To activate the automatic search function, press and hold the TUNE or TUNE buttons for about 2 seconds. In this mode the receiver will automatically tune frequencies until it finds a station.

Selecting Mono or Stereo Sound

Press the AUDIO (ST/MO) button on the remote control to switch between mono and stereo sound in FM tuner mode (when available).

Note: After pressing	the TUNE or TUNE	, MEM or
MEM buttons, the	listening mode will	automatically
change to stereo.

Storing radio stations:

You can easily enter and store up to 40 AM or FM radio stations in the receiver’s memory.

	POWER
	AUDIO(ST/MO)
	SOURCE
MEM +/-	TUNE +/-
MEM +/-

NUMBER

BUTTONS

Manual preset

1.Select FM or AM band by pressing the SOURCE button repeatedly.

2.Tune to the radio station to be stored by pressing the TUNE or TUNE buttons on the remote control.

3.Press the SLOW/MEM button on the remote control.

“PROG” and the preset number will appear on the front panel display.

4. Press the MEM, MEM , or enter the number buttons 0~9, >10 , while “PROG” is still appearing to select

the desired preset memory location.

5.Press the SLOW/MEM button on the remote control to store a frequency in the preset location.

6.Repeat steps 1-5 to store other frequencies.

Retrieving preset stations

1. Press the SOURCE button to select tuner mode.

2. Press the MEM or MEM buttons on the front panel or remote control to select preset stations.