Pioneer Industrial DV-470 operating instructions Connecting up, Connecting using a Scart AV cable

02Connecting up

1Connect the VIDEO OUT and AUDIO OUT L/R jacks to a set of A/V inputs on your TV.

Use the supplied audio/video cable, connecting the red and white plugs to the audio outputs and the yellow plug to the video output. Make sure you match up the left and right audio outputs with their corresponding inputs for correct stereo sound.

See below if you want to use a component or S-video cable for the video connection.

•You can use either of the AUDIO OUT L/R jacks for the audio connection. Each pair of jacks output the same thing.

2Connect the supplied AC power cable to the AC IN inlet, then plug into a power outlet.

Note

•Before unplugging the player from the power outlet, make sure you first switch it into standby using either the front panel STANDBY/ON button, or the remote control, and wait of the -OFF-message to disappear from the player’s display.

•For the above reasons, do not plug this player into a switched power supply found on some amplifiers and AV receivers.

Connecting using a SCART AV cable

A SCART-type AV connector is provided for connection to a TV or AV receiver. The video output is switchable between ordinary composite, S-video and RGB. See AV Connector Out on page 33 for how to set it.

The SCART AV connector also outputs analog audio, so there is no need to also connect the AUDIO OUT L/R jacks.

SCART

TV

h )	CENTER	Y		PB
					AV CONNECTOR (RGB) - TV/AV Receiver
		COAXIAL
UND		OPTICAL	VIDEO	PR	S
		DIGITAL AUDIO OUT	OUT	COMPONENT VIDEO OUT	VIDEO OUT

1Use a SCART cable (not supplied) to connect the AV CONNECTOR (RGB) output to a SCART AV input on your TV (or AV receiver).

Connecting using the S-video output

If your TV (or other equipment) has an S-video (S1) input, you can use the S-video output on this player instead of the standard (composite) output for a better quality picture.

•Use an S-video cable (not supplied) to connect the S-VIDEO OUT to an S-video input on your TV (or monitor or AV receiver).

Line up the small triangle above the jack with the same mark on the plug before plugging in.

10

En