FUNCTION SETUP
Network Connection
Set up the network connection settings in order to use the
Connection Test
After you made IP address/DNS settings or when a LAN cable is connected, always perform the connection test to check if the connection is correctly made.
1In stop mode, press [SETUP].
2Use [K / L] to select , then press [ENTER].
3Use [K / L] to select “Others”, then press [ENTER].
4Use [K / L] to select “Network
Connection”, then press [ENTER].
5Use [K / L] to select “Connection Test”, then press [ENTER].
Connection test will start automatically and the test result will appear right after the connection test finishes.
•“Testing...” : The test is in progress.
• “Pass” | : Connection test is successfully completed. |
• “Fail” | : Connection test failed. Check the |
| connection settings. |
Press [ENTER] to go to the list of network status confirmation screen.
Others
Connection Test
IP Address | xxx.xxx.xxx.xxx |
Subnet Mask | xxx.xxx.xxx.xxx |
Default Gateway | xxx.xxx.xxx.xxx |
Primary DNS | xxx.xxx.xxx.xxx |
Secondary DNS | xxx.xxx.xxx.xxx |
then press ENTER’. |
|
6Press [ENTER] to go back to the previous screen, or press [SETUP] to exit.
Note
•If the connection test passes, you can enjoy the
•If the connection test fails, you may need to change the MAC address settings of your router.
•"Connection Test" is not available when "Disable" is selected in "Network Connection".
Enable(Easy)
Network settings are set to the following settings initially. (In most cases, you can connect to the Internet without making any changes to the default settings.)
- IP Address Setting | Auto(DHCP) |
- DNS Setting | Auto(DHCP) |
- Proxy Setting | Do Not Use |
- Connection Speed | Auto |
- | Allow |
If you want to set the network settings back to the default settings as above (except
1Follow steps 1 to 4 in “Connection Test” on this page.
2Use [K / L] to select “Enable(Easy)”, then press [ENTER].
•The unit will start the connection test automatically and the test result will appear right after the test finishes.
•After the connection test finishes, press [ENTER] to go to network status confirmation screen.
3Press [ENTER] to activate the network settings and set the network connection automatically. Press [SETUP] to exit.
Note
•The setting of
Enable(Custom)
In following cases, select “Enable(Custom)” to set each setting as necessary.
-When connection test failed with the setting of “Enable(Easy)”.
-When instructed by your Internet service provider to make specific settings in accordance with your network environment.
•IP Address Setting / DNS Setting
1Follow steps 1 to 4 in “Connection Test” on this page.
2Use [K / L] to select “Enable(Custom)”, then press [ENTER].
3Use [K / L] to select “IP Address Setting”, then press [ENTER] repeatedly to select the desired setting.
“Auto(DHCP)” : If your router has DHCP server function, select “Auto(DHCP)”.
“Manual” : If your router does not have DHCP server function, select “Manual”.
EN | 45 |