Setup
CONNECTING TO A SURROUND SOUND SYSTEM
DTS SOUND
In order to enjoy DTS sound your A/V Receiver or processor must be equipped with a DTS Decoder. The digital output of the T562 must be set to Analogue Off and the disc must have a DTS soundtrack. There is no analogue output of the T562 for DTS soundtrack.
To the digital input of an amplifier equipped with either
ENGLISH
From the DIGITAL OUT 
(COAXIAL or 
OPTICAL) jacks
From
To
Front 
speaker (left)
Centre speaker
Front speaker (right)
Sub woofer
FRANÇAIS
Rear speaker (left surround)
Rear speaker (right surround)
TO ENJOY DTS SOUND
You need to select from the OSD drop down menu of the T562, Audio, Analogue Off, and Auto, 96K or 48K. If uncertain, select Auto from the Analogue Off menu.
WARNING
Do not set the Digital Audio Output of this DVD player to Analogue Off unless you are connecting the DIGITAL OUT jack of this DVD player to an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the speakers (Refer to Selecting Digital Audio Output. (Refer to Initial Setup Settings, Audio)
NOTES
•Switch the power off on the T562 before switching the
•Refer to the owner’s manual of your receiver as well.
•Before you connect the T562 to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.
•Depending on your Digital sound decoder, the decode rate may be 96 or 48K.
•The output sound of the T562 has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
•Turn off the receiver before you connect or disconnect the T562’s power cord. If you leave the receiver power on, the speakers may be damaged.
SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH
21