ENGLISH FRANÇAIS DEUTSCH NEDERLANDS ESPAÑOL ITALIANO PORTUGUÊS SVENSKA
Preparation
BEFORE OPERATION
AUDIO
DIGITAL AUDIO OUTPUT
Each DVD disc has a variety of audio output options. Set the player’s Digital Audio Output according to the type of audio system you use. DOLBY DIGITAL Bitstream/PCM: Select “DOLBY DIGITAL/PCM” if you connected the DVD Player’s DIGITAL OUT jack to a Dolby Digital decoder (or an amplifier or other equipment with a Dolby Digital decoder). DTS Bitstream/Off: Select “Stream/Off: if you connected the DVD Player’s DIGITAL OUT jack to an amplifier or other equipment with a DTS decoder.
MPEG Bitstream/PCM: Select “Stream/PCM” if you connected the DVD Player’s DIGITAL OUT jack to an amplifier or other equipment with a MPEG decoder. Select when connected to a
AUDIO
Dolby Digital | Bitstream |
DTS | Bitstream |
MPEG | PCM |
Sample Freq. | 48 kHz |
DRC | On |
Move 
Select
SAMPLE FREQUENCY
To change the Sample Frequency setting, first select the desired Digital Audio Output as indicated as above.
If your receiver or amplifier is NOT capable of handling 96 KHz signals, select 48 KHz. When this choice is made, this unit will automatically convert any 96 KHz signals to 48 KHz so your system can decode them. If your receiver or amplifier is capable of handling 96 KHz signals, select 96 KHz. When this choice is made, this unit will pass each type of signal through without any further processing.
DYNAMIC RANGE COMPRESSION (DRC)
With the DVD format, you can hear a program’s soundtrack in the most accurate and realistic presentation possible, thanks to digital audio technology. However, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). Then, you may listen to a movie at a lower volume without losing clarity of sound. Set DRC to On for this effect.
14