NAD owner manual Reset to Factory Default Settings, To Reset the NAD HTR-1

Page 11

Example

With just pressing Macro for AMP as device, you wish to switch on your AV receiver, TV and DVD player; select the Video 1 input on the receiver and activate Play on the DVD player.

1Press the POWER ON/OFF (No. 2) and MUTE keys (No. 14) together for approximately 2 seconds until STATUS LED (No.1) stays red.

2Press the required AMP DEVICE key (No.3); the AMP key will light up.

3Using the numeric key-pad (No. 10) engage Macro Setup Mode for AMP Device: Press 77772. The STATUS LED will flash once. If the code is wrong, the STATUS LED will flash twice.

4Record the Macro by selecting the functions:

•Press POWER ON/OFF (No.2) (command for switching on AV receiver).

•Press SHIFT (No. 9); the STATUS LED changes to green. Press the TUNER/TV device key (No.3). The STATUS LED will change to red again. Press POWER ON/OFF (command for switching on TV).

•Press DVD Device key; press POWER ON/OFF (command for switching on DVD player).

•Press AMP Device key; press VIDEO 1 (inside No. 10) (command for switching AV receiver to Video 1 input).

•Press DVD Device key; press PLAY/ENTER (No. 16) (command for activating Play on DVD player.

5Press the Macro key (No. 23) to store the Macro. The STATUS LED and DEVICE key will go out and the Macro is programmed.

To play back a Macro, select the required device and press Macro. The macro is now executed, for each remote command send in succession, the corresponding DEVICE key will light up briefly.

NOTE

Set-up mode is automatically cancelled if no key is pressed for 15 seconds.

RESET TO FACTORY DEFAULT SETTINGS

Sometimes it may be necessary to reset the HTR-1 to its factory default settings, for instance, if you change many components in your system or do not recall how keys were programmed.

TO RESET THE NAD HTR-1

Press the POWER ON/OFF (No. 2) and SELECT keys (No. 6) together for approximately 5 seconds until STATUS LED (no.1) flashes twice.

NOTE

When you reset the remote to factory default settings, you will LOOSE ALL SETTINGS AND LEARNED REMOTE COMMANDS; ONCE ACTIVATED, RESET CAN NOT BE UNDONE!

GB

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents HTR-1 Page Setting up Pre-programmed codes NAD HTR-1 Universal Remote ControlUsing the HTR-1 Key description T761 function Page Selecting Which Device to Operate Using the NAD HTR-1Introduction GeneralExample Setting UP PRE-PROGRAMMED CodesStatus LED NO.1 SET-UP by Library SearchLook up the Manufacturer ID code for Philips which is Entering Manufacturer ID CodeDevice Code Learning Remote CommandsCode Recall Function Setting UP and Using Macro Function To Reset the NAD HTR-1 Reset to Factory Default SettingsDVD Title Manufacturer Osaki NAD Electronics International
Top Page Image Contents