DTS RV4700 DTS-ES manual Tuning to preset stations, Scanning preset stations in sequence

Select the desired preset number(1~30)		Repeat the above steps to to
3 and press the MEMORY/ENTER button.		4 memorize other stations.
TUNING/PRESET	MEMO/ENTER

•When using the NUMERIC buttons on the remote control.

Examples) For “3” :	MEMORY BACKUP FUNCTION
within 2 seconds	The following items, set before the receiver is turned
For “15” :
	off, are memorized.
For “30” :	• INPUT SELECTOR settings
• The station has now been stored in the memory.	• Surround mode settings
	• Preset stations, etc.
• When using the NUMERIC buttons, the station is
	Note : If the electricity fails or the AC input cord is
stored automatically without pressing the MEMORY/
	disconnected for about 2 weeks, they are all
ENTER button.
	cleared. So you should memorize them again.

•A stored frequency is erased from the memory by storing another frequency in its place.

• If “MEMO” goes off, start again from the above step .
Tuning to preset stations		2	Select the desired preset number.
1	After selecting the tuner as input source,			TUNING/PRESET
	select the preset tuning mode.
	T/P MODE	• When using the NUMERIC buttons on the remote
		control.
		Examples)	For “3” :
			For “15” :	within 2 seconds
				within 2 seconds
			For “30” :	(or	)
• Then “PRESET” lights up.		• When selecting the desired preset number with the
		NUMERIC buttons, the desired preset station will be
		tuned to automatically without selecting the preset
		tuning mode.

Scanning preset stations in sequence

DISC

P.SCAN

•The receiver will start scanning the stations in the preset sequence and each station is received for 5 seconds.

•At the desired station, press this button again to stop scanning.

26