DTS RV4700 DTS-ES manual Entering a Setup Code, For Power ON/OFF

ENTERING A SETUP CODE

•This remote control can control up to eight different components.

•Before operating audio and video components using the remote control supplied with this receiver, the setup code for each component should be entered.

1	Turn on the component you want to control.				2	Find the setup code for your component
						referring to “Set-Up Code Table” in the
						operating manual of this remote control.
Example) When entering the setup code for this					Example) The correct setup code for this receiver is
	receiver, turn on this receiver.					“001”.
3	Press the corresponding DEVICE and the				4	Enter the 3 digit setup code aiming the
	MUTE buttons simultaneously.					remote control at the REMOTE SENSOR
						on the component.
	For receiver or amplifier :				For	"001" :	0	0	1
	For CD player	:
					For	"102" :	1	0	2
	For CABLE	:
					• Your component will be turned off when the correct
					setup code is entered.
• Then the LED lamp and the corresponding DEVICE					• Continue to enter the corresponding codes until your
button on the remote control light up for 20 seconds.					component turns off.
					• If the LED lamp and the corresponding DEVICE
					button go off, start from the step					again.
5	Press the corresponding DEVICE button to				6	Operate the component using the
	store the setup code.					corresponding function buttons on the
						remote control such as POWER, CH /
						and VOL /			buttons, etc.
	For receiver or amplifier :				• If any of the buttons do not perform as they should start
	For CD player	:			from step	again to enter the next setup code.
					Notes:
	For CABLE	:			• Some audio and video components have separate buttons
					for POWER ON/OFF.
					In this case, press the corresponding DEVICE button to
					turn the component ON and press the POWER button to
• Then the LED lamp and the corresponding DEVICE					turn the component OFF.
					• If there is no correct setup code or if the
button will flicker twice.
					Manufacturer/Brand for your component is not listed in
					“Set-Up Code Table” in the operating manual of this
7	Repeat the above steps		to	for each	remote control, please use the “Auto Search Method” on
					page 10 in the operating manual of this remote control.
	of your other components.
					• Although each setup code is designed to work with many
					different modes, certain codes may not work with some
					models. (Also, certain codes may only operate some of
					the functions available on a given model.)

14