NAD L 73 owner manual Rear Panel, Español Italiano Português

Page 10

ENGLISH FRANÇAIS DEUTSCH NEDERLANDS

Identification of controls

REAR PANEL

ATTENTION!

Please make all connections to your L73 receiver with the unit unplugged. (It is also advisable to power-down or unplug all associated components while making or breaking any signal or AC power connections.)

230 volt

120 volt North

230 volt

European

American

European

version only

version only

version only

ESPAÑOL ITALIANO PORTUGUÊS

1SWITCHED AC OUTLET: This convenience jack can supply switched power to another component or accessory. It is powered on and off by the front panel POWER key (or the HTR L73’s ON and OFF keys).

NOTE

The total draw of all devices connected to this jack must not exceed 100 watts.

2AC POWER CORD: Connect AC power cord to the Voltage according to the model, 120 V for US and 240 V for Euro models.

3MONITOR OUT: Connect to video input of the monitor/television, using quality dual-RCA and/or S-Video cables designed for video signals. In general, the S-Video connection is superior and should be used if your TV/monitor provides the corresponding input.

4COMPONENT VIDEO IN: Connect inputs to component-video signal or wide-band component video from a source component such as a HDTV tuner.

6FM ANTENNA: The supplied wire “dipole” FM antenna will connect to the FM connector using the supplied “balun” adaptor. It will usually work best when mounted on a vertical surface such as a wall, with arms fully outstretched forming a horizontal “T” perpendicular to the origin point of the signal. Experiment with placement and orientation of to yield the clearest sound and lowest background noise. In areas of difficult FM reception an external FM antenna can yield dramatic gains in quality; consult your NAD audio specialist or a professional antenna installer.

7AM ANTENNA: The AM loop antenna supplied with the L73 (or a suitable replacement) is required for AM reception. Open the clip terminal lever; insert the wire and close, ensuring that the lever locks the wire in place. Testing different positions for the antenna may improve reception; vertical orientation will usually produce the best results. Antenna proximity to large metal objects (appliances; radiators) may impair reception, as will attempts to lengthen the wire to the loop.

NOTE

SVENSKA

5COMPONENT VIDEO OUT: Connect the L73 COMPONENT VIDEO OUT to the component-video input of a compatible video monitor/TV. Be sure to observe consistency in connecting the Y/Cr/Cb jacks (some source and TV components label these Y/Pb/Pr) to the corresponding sources/inputs; do not rely purely on the colour coding of the jacks, which may not always be consistent among brands. The routing of the component-video input is fixed: COMPONENT VIDEO OUT jack will only display the internal DVD and CAB/SAT video signals.

NOTE

An external AM antenna can improve long-distance reception substantially; consult your NAD audio specialist or a professional antenna installer. Do not connect anything other than a loop antenna to the AM ANTENNA terminal. Do not remove the AM loop antenna.

The L73’s component-video output is a fully wide-band output, compatible with all HDTV formats. The L73 will display its on- screen menus on its component-video output.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents DVD Receiver FCC Warning Safety PrecautionsDo not Stare Into Beam FCC Notice Industry Canada RequirementSafety Information Important Information for UK CustomersRecord Your Model Number NOW, While YOU can see IT Table of Contents Getting the Most from the NAD L73 Upgradability About the HTR L73 System Remote ControlEase of USE QuickstartIdentification of controls Front PanelIdentification of controls Rear Panel Español Italiano PortuguêsImportant Note Dealing with HUM and Noise Setting UP the L73Getting Started About the ON-SCREEN Displays OSD and FRONT-PANEL ReadoutDisplaying the L73 RECEIVER’S OSD Setting L73 OSD Language Receiver Section onlyInput Setup Navigating the OSD and Making ChangesInput Selector Surround Mode Speaker ConfigurationSetting Speaker Configuration Channel LevelsDelay Time Setting Level TrimSetting Speaker Delay Time Selecting Sources Using the L73Adjusting the Volume Muting the SoundAbout DVD/SVCD/VCD/CD Using the L73’S DVD/VCD/CDPress OPEN/CLOSE the Disc Tray Opens Region Management InformationOSD Navigation Video Setup Video Setup MenuTitle and Menu Buttons OSD LanguageFormat Signal ModeDisc Video OSD Scan TypePlaying CD, VCD, SVCD, DVD Programming CD VCD Svcd Parental Control PasswordRating Level Random Play CD VCD SvcdRandom Play Slide Show Mode JpegPlaying MP3 WMA and Jpeg CD-R/CD-RW RepeatUsing the L73’S AM/FM Radio About RDS Choosing the FM Mute / ModeViewing RDS Text Enhanced Stereo About the L73’S Surround ModesEars StereoSelecting Surround Modes Dolby Digital / DTSDolby Virtual Speaker and Headphone Dolby Digital Delay Time Adjusting Surround ModesDTS Delay Time Enhanced Stereo / Ears Delay TimeAdjusting the Tone Controls Adjusting Level Trim on the FLYTo Adjust Level Trim About the 12 V Trigger OUTSpecifications Using the HTR L73 Remote ControlControlling the L73 Learning Codes from Other Remotes Cancel OperationPUNCH-THROUGH Macro Commands Copy a Command from Another KEYRecording Macros Delete Mode KEY-ILLUMINATION TimeoutFactory Reset Executing MacrosSearch Mode Loading CODE-LIBRARIESChecking CODE-LIBRARY Number Summary of HTR L73 ModesTroubleshooting DVD Section SpecificationsPhysical Specifications Amplifier SectionReference L73 Manual 01/05 Korea
Top Page Image Contents