Copy a Command from Another KEY, Macro Commands

Operation

USING THE HTR L73 REMOTE CONTROL

COPY A COMMAND FROM ANOTHER KEY

You may copy a command from any HTR L73 key to any other. To copy a key function, after entering the Learning Mode, and pressing the desired key to be copied to, simply press the device key from which you wish to copy, having first pressed its Device Selector key if it resides on another “page.” The status LED will turn green; press the Device Selector key again to exit Learning Mode.

Example: Copy the Pause command from the DVD page to the AMP

key:

•

On the HTR L73, simultaneously press-and-hold “AMP” and

(OPEN/CLOSE); the Learn LED

turns steady green.

•

Press

(pause); the Learn LED turns amber.

•

Press “CD”; press

(pause); the Learn LED turns green.

• Press “AMP” again to exit the learning mode.

NOTE

The copy and punch-through functions are similar. However, if you copy a command and then subsequently delete, or over-write the original (source-key) command , the copied-to key’s command remains unchanged. If you punch-through to a command and then delete or over-write the original key, the punched-through functions also change accordingly.

MACRO COMMANDS

A “macro” command is a series of two or more remote codes issued automatically from a single keypress. You might use a macro to automate a simple command sequence, such as, “Turn on the DVD player and then press ‘play.’” Or you might compose an elaborate macro to power up an entire system, select a source, choose a SURROUND MODE, and begin playback-again, all from a single keypress. The HTR L73 can store one macro on each of its function keys (these exclude the Device Selector keys).

NOTE

Macros are independent of the currently selected device.

RECORDING MACROS

To record a macro, simultaneously press-and-hold for 3 seconds both the “MACRO” key and the HTR L73 function key to which you wish to assign the macro, until the status LED turns green. The macro button will also light up. Press the sequence of function keys to be recorded into the macro, being sure to first press the requisite Device Selector key for each function (you may switch devices while recording the macro as many times as necessary), allowing you to create macro containing commands from more than one Device Selector “page.” When you have finished entering the desired command sequence, press “MACRO” again to store the macro; the Learn LED and “MACRO” key illumination will turn off.

NOTE

Each macro can store a maximum of 64 command steps. If you exceed this number, the macro will be stored automatically after the 64th command is added.

Example: Record a Macro to the “0” key to Turn on the L73, Select the DVD Input, and

Commence Playback:

•On the HTR L73, simultaneously press-and-hold “MACRO” and “0” (numeric zero); the Learn LED turns steady green.

•Press “AMP”; press “ON”; press “1” (orange “DVD”); press “DVD”; press “play” (the Learn LED blinks as each step is added).

•Press “MACRO” again to exit the macro-record mode.

To clear a macro, perform the above steps without entering any functions.

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH