NAD L 53 owner manual Copy a Command from Another Button, Macro Commands, Recording Macros

Operation

USING THE HTR L53 REMOTE CONTROL

COPY A COMMAND FROM ANOTHER BUTTON

You may copy a command from any HTR L53 button to any other. To copy a button function, after entering the Learning Mode, and pressing the desired button to be copied to, simply press the device button from which you wish to copy, having first pressed its Device Selector button if it resides on another “page.” The status LED will turn green; press the Device Selector button again to exit Learning Mode.

Example: Copy the Pause command from the DVD page to the AMP					button:
•	On the HTR L53, simultaneously press-and-hold “AMP” and			(OPEN/CLOSE); the Learn LED
	turns steady green.
•	Press	(pause); the Learn LED turns amber.
•	Press “CD”; press		(pause); the Learn LED turns green.
• Press “AMP” again to exit the learning mode.

NOTE

•The copy and punch-through functions are similar. However, if you copy a command and then subsequently delete, or over-write the original (source-button) command , the copied-to button’s command remains unchanged. If you punch-through to a command and then delete or over-write the original button, the punched-through functions also change accordingly.

MACRO COMMANDS

A “macro” command is a series of two or more remote codes issued automatically from a single buttonpress. You might use a macro to automate a simple command sequence, such as, “Turn on the DVD player and then press ‘play.’” Or you might compose an elaborate macro to power up an entire system, select a source, choose a SURROUND MODE, and begin playback-again, all from a single buttonpress. The HTR L53 can store one macro on each of its function buttons (these exclude the Device Selector buttons).

NOTE

• Macros are independent of the currently selected device.

RECORDING MACROS

To record a macro, simultaneously press-and-hold for 3 seconds both the “MACRO” button and the HTR L53 function button to which you wish to assign the macro, until the status LED turns green. The macro button will also light up. Press the sequence of function buttons to be recorded into the macro, being sure to first press the requisite Device Selector button for each function (you may switch devices while recording the macro as many times as necessary), allowing you to create macro containing commands from more than one Device Selector “page.” When you have finished entering the desired command sequence, press “MACRO” again to store the macro; the Learn LED and “MACRO” button illumination will turn off.

NOTE

•Each macro can store a maximum of 64 command steps. If you exceed this number, the macro will be stored automatically after the 64th command is added.

Example: Record a Macro to the “0” button to Turn on the L53, Select the DVD Input, and

Commence Playback:

•On the HTR L53, simultaneously press-and-hold “MACRO” and “0” (numeric zero); the Learn LED turns steady green.

•Press “AMP”; press “ON”; press “1” (orange “DVD”); press “DVD”; press “play” (the Learn LED blinks as each step is added).

•Press “MACRO” again to exit the macro-record mode.

To clear a macro, perform the above steps without entering any functions.

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

25