Lenoxx Electronics DVD-2002 Player only plays Ntsc region 1 DVD discs made for USA use

TROUBLE SHOOTING

DVD

	Symptom		Remedy
The subtitle or language is not what you		Go to page 15.
selected.
The	icon appears in the left top corner.	The feature or action you selected cannot be done at this time or with this disc.
Door cannot open from the set.		Wait a few seconds, this function takes a little longer, also try the EJECT button on
		the REMOTE control.
“ No Disc ” shows on left top corner.		The disc is upside down or a non-playable disc was inserted. Change the disc.
“Wrong Region Disc” shows on left top		Press the EJECT button and replace a good USA standard disc into the player. This
		player only plays NTSC region 1 DVD discs made for USA use.
corner.
		This set will not play PAL or other foreign DVDs (due to legal reasons).
		1.	Clean the disc.
“Damaged Disc” shows on left top		2.	See if the disc is defective by trying another disc (If disc is very badly scratched or dirty,
corner.			it will not play).
		3. check if the DVD disc is for Region 1.
No picture.		1.	Check if the TV or VIDEO is switched on.
		2.	Check if the proper AV input is selected on your TV set video inputs (some TV sets have
			3 or 4 different inputs).
		3.	Check the Audio / Video cables.
Images appear distorted.		If faces seem stretched and too long, your TV shape may be adjusted to 16:9 ratio.
		Please adjust it to 4:3 for better results or match to your TV type, see page 16.
		1.	Buy a newer TV with these jacks.
If your TV set does not have Audio / Video		2.	You may try using your VCR’s jacks but the color may be distorted due to macrovision
input jacks.			licensed DVD protection (against copying discs).
		3.	Talk to your dealer (or local TV repair shop) if they can sell you an RF adaptor which may be
			able to convert the signals for inputting into the TV’s RF input (antenna) jacks. However, your
			results will never be as good as a new modern TV with proper input jacks.
		If a button is pressed too fast over and over, the signals may jam the circuits inside. To restore
Picture is frozen		to normal, press OPEN/CLOSE or EJECT or remove the AC power plug for 2 minutes and
		reinsert to reset the circuits.
Picture is distorted.		Do you connect your DVD player to your VCR? Please disconnect from VCR.
Screen saver appears on TV screen.		Turn off screen saver by press any button on the REMOTE control.
Menu is in foreign language.		Please reset the language to English by following Page 15.
Can not copy discs to VHS video tapes.		You can’t copy most discs due to copy protection built into the disc.
Disc will not eject.		1.	When the disc is busy loading (or during play), the disc must stop spinning first, then
			the tray will open. Please be patient, it may take over 30 seconds.
		2.	If you put a disc into the tray UPSIDE DOWN, the DVD player will try to read the data
			but there will be no data to read. It may take as long as 40 seconds for the attempts to
			finish and the door to open.
Picture is too short.		Change the picture screen type, see page 16.
REMOTE will not work.		Reset the REMOTE by removing the batteries and pressing a button for 2 minutes, then replace
		the batteries.

28 IB-DVD-2002-WC-ZR-E-V1