8
OPERATING THE
REMOTE CONTROL
Battery Installation
1.Push down and out on the battery Compart- ment cover to remove it.
2.Insert the two "AAA" batteries into the battery compartment of the remote control, making sure the + and - signs on the batteries and inside the battery compartment match up.
3.Replace the battery compartment cover.
Notes:
Do not mix batteries from different manu- facturers, nor old ones with new.
If the remote control will not be used for an extended period of time, remove the batteries to prevent
Remove dead batteries immediately to prevent
If battery leakage occurs, wipe the battery liquid from the battery compartment, then replace both batteries.
Always replace both batteries at the same time, using new, fully charged batteries.
Life expectancy of batteries may vary depending on amount of use.
Using the Remote Control
Point the remote control at the remote sensor on the DVD receiver. When the signal is received from the remote, the unit will function accordingly. The remote will operate to approximately 16' from the remote sensor at an angle of around 30 each direction.
Notes:
Do not direct the remote sensor toward any light source, such as direct sunlight or a strong fluorescent light, as it may cause the unit to not operate correctly.
When other remote controls are used nearby or when the remote is used near
equipment using infrared rays, interference
may occur.
Placing an object on the remote control
may cause it to inadvertently depress a
button, changing a function and shortening
battery life.
Do not glaze the front of the DVD receiver with colored glass, as it may cause interference with normal operation of the controller.
Make sure there is no barrier between the remote control and remote sensor, as it could prevent the unit from receiving the signal.
Do not spill water or put wet items on the remote control.
Never disassemble remote control.
BATTERIES
INCORRECT USE OF BATTERIES MAY CAUSE THEM TO LEAK, CORRODE OR EXP LODE.