Changing or Installing the Hard Drive
Note: the following instructions are for installing or changing the hard drive. If your DVR already has a hard drive pre- installed, and you don’t want to change it, disregard these steps.
1.Ensure the DVR is switched off and unplugged from mains power.
2.Locate and remove the 4 screws on the rear of the DVR, and the 2 from each side.
3.Pull up the top case of the DVR.
4.Locate the 2 screws holding down the hard drive chassis. Remove these screws and remove the HDD from the DVR.
5.Push the metal clip on the SATA cable (single red or orange cable) to unplug the cable from the hard drive. Unplug the power cable (2 black, 1 yellow, and 1 red cable) from the back of the hard drive.
6.If replacing the hard drive, put the new hard drive into the chassis.
7.Screw in the hard drive to chassis as in step 5, and attach the chassis to the DVR case as in step 4. Remember - the HDD goes in upside down, as shown in the image to the right.
8.Replace the top of the case.
9.Screw in the remaining screws to the sides and back of the DVR as in step 2.
Remove
3
4
5
Power Cable | SATA Cable |
|
70
