General | MacroSystem Digital Video DVD-Arabesk 2 manual

1. General

Thank you for buying “DVD-Arabesk 2”!

We thank you for your trust and hope that this product will meet your expectations.

This guide will show you how to easily create your own DVD.

We are available for any questions or suggestions you may have. You will find addresses and telephone numbers in the Casablanca manual.

Please have your device’s serial number or your customer number ready when contacting us.

2.Installing and Starting the Program

In order to install “DVD-Arabesk 2” you will need the SMART EDIT system software (at least version 2.5).

Leave your Casablanca turned on and select the “Install Product” button in “System Settings”. After the corresponding window has appeared, insert the installation SmartMedia card into the Casablanca drive so that the gold contacts are facing down and the folded corner is pointing forward to the left (in the direction of the Casablanca).

After you have inserted the card, you will see the software “DVD-Arabesk 2” displayed in the window. Select it in the list and click on “activate”. A numeric keypad is displayed for entering the key code you have obtained from your dealer.

After that, a message is displayed indicating that installation is finished. You can then remove the SmartMedia card which will restart the Casablanca system.

If you want to install “DVD-Arabesk 2” as a demo version only (also possible for Casablanca systems without a DVD burner), select the program in the list and click “activate”.

If you are working with SMART EDIT version 2.5 or higher, click on the “Cancel” button in the displayed number code window.

If you are working with SMART EDIT version

3.1or higher, click on the “Demo” button in the displayed number code window.

The word Demo now appears after the program name. Click on “Ok” to confirm and then remove the SmartMedia card.

“DVD-Arabesk 2” is now installed as a demo version.

Note: In demo mode only 200 MB of the total

4.7GB DVD capacity are available for inserting a film. Demo mode therefore allows you to work with only very short projects!

In order to use the “DVD-Arabesk 2” program, enter the “Finish” menu of your Casablanca. You will see the program “DVD-Arabesk 2” displayed in the list in the lower left area. Select it now if it has not already been automatically selected.

After you have created the complete video with transitions, titles and audiom, click on the “Start program” button to the right in order to start “DVD-Arabesk 2”.

In case a message is shown indicating that your firmware is too old, you can obtain this software update free of charge from your dealer.

You will then be able to fully use or demo “DVD-