Toshiba 960-809 4.27 Sensor board

4.27 Sensor board 4 Replacement Procedures
4.27 Sensor board
Removing the Sensor board
The following describes the procedure for removing the sensor board. (See Figure 4-43.)
1. Remove the sensor board from the slot.
2. Disconnect the sensor cable from the connector on the sensor board.
Sensor board
Sensor cable
Guide
Hole
Figure 4-43 Removing the sensor board
Installing the Sensor board
The following describes the procedure for installing the sensor board. (See Figure 4-43.)
1. Connect the sensor cable to the connector on the sensor board.
CAUTION: Connect the connecter on which the acetate tape is not wrapped to the
sensor board. The connector on which the acetate tape is wrapped is
connected to the system board. Be careful not to connect the connectors
oppositely.
2. Install the sensor board to the slot while inserting the hole into the guide.
PORTÉGÉ M780 Maintenance Manual (960-809) [CONFIDENTIAL] 4-69