Troubleshooting Procedures
Procedure 2 Connector Check and Replacement Check
The Digitizer is connected to the system board as below.
Check 1 If any of the connections are loose, reconnect firmly and repeat Procedure 1. If there is still an error, go to Check 2.
Check 2 The touch screen may be damaged. Replace it with a new one following the instructions in Chapter 4, Replacement Procedures and check the operation. If the problem still exists, perform Check 3.
Check 3 The web camera/digitizer/fingerprint sensor /sw board cable may be damaged. Replace it with a new one following the instructions in Chapter 4, Replacement Procedures. If the problem still exists, perform Check 4.
Check 4 The Digitizer may be damaged. Replace it with a new one following the instructions in Touch screen Troubleshooting and Chapter 4, Replacement Procedures and check the operation. If the problem still exists, perform Check 3.
Check 4 The system board may be damaged. Replace it with a new one following the instructions in Chapter 4, Replacement Procedures.
[CONFIDENTIAL] | PORTEGE M780 Maintenance Manual |
