Installation and Operation
MULTISET PRO® -
Cabinet Installation
1. | Surface or recess mount on wall using appropriate |
|
| wall anchors. Use wall anchors capable of support- |
|
| ing up to | Figure 1 |
Note: All wiring should be in accordance with local |
| |
regulations and the National Electrical Code. All |
| |
wiring shall enter and exit the cabinet via the provided |
| |
knock outs at the top or bottom of the cabinet. |
| |
2. | Terminate 120VAC lines and neutrals to terminal |
|
| blocks. Do not use common neutrals |
|
3. | Connect lighting loads to the load terminal block. |
|
| Be sure to match proper load with the correct |
|
| device (refer to device location sticker on front of |
|
| cabinet). |
|
4. | Connect ground to dimming cabinet. |
|
5. | Connect network "purple" wire to additional cabi- |
|
| nets (when necessary). |
|
Each Cabinet Cover has a swinging radius of 21"
BACK
1
1
1
1
Features
1. Anchor mounts (Figure 1) | Figure 2 | Dimmer |
| ||
|
| Detail C |
2.Terminal blocks (Figure 2)
3.Ground terminal strip
2
Terminal Blocks
(see descriptions below)
4. Dimmer mounting panel
Detail C
3
Enclosure::
5. Cabinet latch
4
-Can be ordered separately for
6. Door and door frame
Note: No common neutrals
6
5
3
Order part number: MDC20ENC
Interior:
-Terminal Blocks
-Mounting Back Plane
-Dimmer(s) Mounting Panel
-Door and Door Frame
-Can be ordered separately and
installs into MDC20ENC
Order part number: MDC20INT*
*Requires part number MDC20ENC
2 | Terminal Blocks: |
| Installed and positioned according to dimmer/master |
FRONT | configuration for each cabinet. |
-Red Terminal Blocks: Load wire terminations
-Black Terminal Blocks: Power feed terminations
-Blue Terminal Block: MultiSet Pro purple wire terminations
-White Terminal Block: Neutral wire terminations
-Grey Terminal Block: Lightolier Controls PowerSpec HDF dimming ballast TAN wire termination.
3
