Setting the Button Brightness Ellipse Series

Installation and Operation

MULTISET PRO® - PRE-WIRED DIMMING CABINET MDC20

Setting the Button Brightness (Ellipse Series)

The brightness level of each Ellipse Master Control Station button can be programmed to 100% (factory default), 75%, 50%, or 25%.

To change the setting:

1.On a 5-Scene Master, press and hold buttons “B” and “D” simultaneously for 3 seconds (on an 8- Scene Master, press buttons “H” and “J”). On a 5-Scene Master, buttons “A” thru “D” illuminate (on an 8-Scene Master, buttons “G” thru “J” illuminate). The blinking LED displays the current LED brightness setting. The continuously-illuminated LEDs display the available brightness set- tings that can be selected.

2.To change the brightness setting, press the button illuminated at the desired brightness. This button will begin blinking.

3.To save the selected brightness and exit the mode, press the ON button on a 5-Scene Master (or the “E” button on an 8-Scene Master). All buttons on that master will now have the new brightness setting.

Figure 13

5-Scene 8-Scene LED Master Master Brightness

A	G	100%
B	H	75%
C	I	50%
D	J	25%

Typical Wiring Diagram

To Lighting Loads

(One dimmed 120VAC Line / Neutral per circuit)

Figure 14

See Page 3 for Terminal Block Wiring Descriptions.

Note: No Common Neutrals on Dimmed Circuits.

Note: Knockouts are provided on top and both sides.

A B C D

Up to 20 Circuits...

120VAC Line / Neutral

Circuit Breaker Panel

MHPWDC20

Connecting Multiple Cabinets

Figure 15

MDC20

MHPWDC20

MDC20MDC20

A	B	C	D	A	B	C	D	A	B	C	D
1				1				1
2				2				2
3				3				3
4				4				4
5				5				5

Purple Wire

Up to 30 MultiSet Pro® Devices may be controlled as one system.

Lightolier MDC20 manual Setting the Button Brightness Ellipse Series, Typical Wiring Diagram

Models: MDC20

Setting the Button Brightness (Ellipse Series)

Typical Wiring Diagram

Connecting Multiple Cabinets