Connecting to a TV

Turn on the TV

Remote Control

Controlling a TV with the Remote

The remote can also be set up to control most TVs. To program the remote, use the code that corresponds to your brand.

Methodt 1 Through Video and Audio Outputs

2 Point the DVD’s remote at the TV.

3 While holding the TV POWER button down, enter the code for your brand.

4 If the TV turns off, setup is complete. Enter other codes of the same brand if the first code does not work.

TV Codes

Code	Brand	Code	Brand
01	SAMSUNG_1	16	SHARP_1
02	SHARP_2	17	ZENITH
03	SONY	18	LG_3
04	MAGNAVOX	18	DAEWOO_8
05	SANYO_1	20	SANYO_2
06	LG_2	21	EMERSON
07	RCA	22	SHARP_3
08	LG_1	23	SAMSUNG_4
09	TOSHIBA	24	PANASONIC_2
10	HITACHI	25	NOBLEX
11	JVC	26	TELEFUNKEN
12	PANASONIC_1	27	NEWSAN
13	MITSUBISHI_2	28	LOEWE
14	SAMSUNG_2	29	RCA2
15	SAMSUNG_3

Connections

Video Cable

For Samsung_1 TVs

• While holding down the TV POWER button, enter 0 and then 1.

• The remote may not be able to control every model TV of the brands listed.

If remote does'n operate properly:

•Check the polarity + - of the batteries (Dry-Cell)

•Check if the batteries are drained.

•Check if remote sensor is blocked by obstacles.

•Check if there is any fluorescent lighting nearby.

Audio Cable

1 Connect the DVD player's AUDIO OUT (L/R) and VIDEO OUT to your TV's AUDIO IN and VIDEO IN.

2 Press"AV2".the TV/VIDEO button on the remote control to set the TV to "AV1" or

Types of Color Video Signals

•Video (Composite): A single video signal that is a composite of the black and white information (Y) and the color information (C).

•S-Video: Provides a sharper picture than composite video by separating the color information (C) from the black and white information (Y).

•Component Video: Provides the most clear and sharp picture by separating the signal into full-bandwidth black and white information (Y), blue information (Pb), and red information (Pr).