Samsung DVD-V4700 Basic Connections/Auto Setup, Time, counter position, time remaining or, Plug

Front Panel Overview

			1			2	3				4
5	6	7	8	9	10	11	12	13	14 15	16 17	18

1	DVD DECK	10	RECORD
2	DVD OPEN/CLOSE	11	EZ VIEW
3	VCR DECK	12	FRONT PANEL DISPLAY

Front Panel Display

1 2 3

4 5

1	When the light is on, DVD is operating.
2	The time, counter position, time remaining or
	current deck status is indicated.
3	VCR is activated.
4	DVD or CD media is loaded.

Basic Connections/Auto Setup

You will need to connect the DVD-VCR to a TV and run Auto Setup. The Auto Setup will automatically search for channels and then set your DVD-VCR's internal clock.

NOTES:

•See Appendix A for Advanced Connections.

•Standard RF or Line connection between your TV and DVD-VCR are required to run DVD+VCR

setup menu, even if you connect S-Video or Component Video Output for a better picture quality.

1Connect the RF Antenna Cable to your DVD-VCR Connect an external indoor/outdoor antenna or wall outlet antenna cable to the Ant-In jack on the rear panel.

4	VCR EJECT	13	CHANNEL /
5	POWER	14	DVD-VCR SELECT
6	REWIND/REV	15	PROGRESSIVE
7	STOP	16	COMPOSITE VIDEO JACK
8	PLAY/PAUSE	17	LEFT AUDIO JACK
9	FAST-FORWARD/FWD	18	RIGHT AUDIO JACK

5 VHS videotape is loaded.

1

From Antenna or Cable

2

To TV’s Antenna Input

Rear Panel

		1	2	3	4	5	6	7	8	9
1	S-VIDEO OUT					6	LINE IN 1
2	DIGITAL AUDIO OUT(OPTICAL)					7	LINE OUT TO TV (COMPOSITE)
3	DIGITAL AUDIO OUT(COAXIAL)					8	RF ANTENNA INPUT
4	COMPONENT VIDEO OUT					9	RF OUT TO TV (RF THROUGH ONLY)

5AUDIO LINE OUT TO TV (S-VIDEO OR COMPONENT)

Insert Batteries into Remote

•Remove the battery cover on the remote

•Insert two 1.5V “AAA” batteries as shown, making sure of the correct polarities(+/-)

•Slide the cover back onto remote.

2Connect your DVD-VCR to a TV

RF Connection

Using the RF antenna cable, connect the OUT jack (TO TV) on the rear panel of your DVD-VCR to your TV’s Antenna Input.

Line Connection

Using an RCA-type audio/video cable (red, white, yellow), connect the LINE OUT jacks on the rear panel of your DVD-VCR to your TV's Line In jacks. Use the three cables as follows: red for right audio, white for left audio, and yellow for video.

NOTE: If your TV is equipped with RCA jacks, it is better to use the Line Connection method.

3Plug In

Your DVD-VCR's power should be plugged into a standard 120V/60Hz wall outlet. Avoid pressing any buttons on the remote control or on the unit during an Auto Setup. While your DVD-VCR is running an Auto Setup, “AUTO” will blink. When Auto Setup is complete, the current time will be displayed on the front panel displayed. In case Auto Clock set fails to locate a channel to set the clock, you should set the clock manually. See page 12.

3

ENG-6 ENG-7