Operation
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the WIRELESS HOME AV CENTER (i.e., an antenna or a cable system).
TVChannel
Select Antenna | : Air | √ |
Auto Program |
| √ |
Add/Delete |
| √ |
Fine Tune |
| √ |
Signal Strength |
| √ |
Move | Enter | Return |
1
Press the MENU button. Press the ▲ or ▼ button to select “Channel”, then press the ENTER button.
TV | Channel |
|
Select Antenna | : Air | Air |
Auto Program | Cable | |
|
| |
Add/Delete |
|
|
Fine Tune |
|
|
Signal Strength |
|
|
Move | Enter | Return |
|
|
|
2
Press the ▲ or ▼ button to select “Select Antenna”, then press the ENTER button.
TVChannel
Select Antenna | : Air | Air |
Auto Program | Cable | |
|
| |
Add/Delete |
|
|
Fine Tune |
|
|
Signal Strength |
|
|
Move | Enter | Return |
3
Press the ▲ or ▼ button to select “Air” or “Cable”, then press the ENTER button.
4
Press the MENU button to exit.
Storing Channels in Memory (Automatic Method)
TVChannel
Select Antenna | : Air | √ |
Auto Program |
| √ |
Add/Delete |
| √ |
Fine Tune |
| √ |
Signal Strength |
| √ |
Move | Enter | Return |
1
First, select the correct antenna (Air and Cable). See steps on previous page. Press the MENU button. Press the ▲ or ▼ button to select “Channel”, then press the ENTER button.
TV | Channel |
| |
| Select Antenna | : Air | √ |
|
|
|
|
| Auto Program |
| √ |
| Add/Delete |
| √ |
| Fine Tune |
| √ |
| Signal Strength |
| √ |
| Move | Enter | Return |
|
|
|
|
2
Press the ▲ or ▼ button to select “Auto Program”, then press the ENTER button.
➤Quick way to access the Automatic Channel Setting:
Just press the “AUTO PROG.” button on the remote control.
TV | Auto Program |
|
Air |
|
|
STD |
| |
HRC |
| |
IRC |
|
|
Move | Enter | Return |
3
Press the ▲ or ▼ button to select the correct signal (Air, STD, HRC, and IRC). Select an option and then press the Enter button.
If you are connected to an antenna (Air), leave “Air” displayed. If you are connected to a cable, press the ▲ or ▼ button to display the type of cable system “STD”, “HRC” or “IRC”. (If you are not sure which type of cable system you have, contact your cable company).
Auto Program
It will take about several minutes.
Would you like to continue?
Start
Enter | Return |
Auto Program |
|
Air Ch | 23 |
Stop |
|
Enter | Return |
4
Press the ENTER button. The PDP will begin memorizing all of the available channels. After all the available channels are stored, the Auto program menu reappears. Press the MENU button to stop.
Note
●Auto Program may take a few minutes to process.
8