Samsung 570VTFT manual Getting Help, Warm-up Time, Monitor

Page 11

Setting up Your Monitor

If the monitor is functioning properly, you will see a white box with a red border and black text inside as shown in the following illustration:

No Connection

Check Signal Cable

Figure 5. Monitor self test screen

The three boxes inside the border are red, green and blue. Failure of any of the boxes to appear indicates a problem with your monitor. This box also appears during normal operation if the video cable becomes disconnected or damaged.

4	Turn off your monitor and reconnect the video cable; then turn on both your computer
	and the monitor.

If your monitor screen remains blank after using the previous procedure, check your video controller and computer system; your monitor is functioning properly.

Getting Help

If your monitor does not display an image, check your cable connections and refer to “Troubleshooting” on page 20. If you experience difﬁculties with the quality of the displayed image, run Auto Adjustment (see page 11) and refer to “Adjusting Your LCD” on page 10 or “Troubleshooting” on page 20.

Warm-up Time

All LCD monitors need time to become thermally stable the ﬁrst time you turn them on each day. Therefore, to achieve more accurate adjustments for parameters, allow the LCD monitor to warm (be on) for at least 20 minutes before making any screen adjustments.

English 9

Image 11

Contents SyncMaster 570V TFT SyncMaster 560V TFT Page Table of Contents Do not Open Safety InstructionsUnpacking Your Monitor Kensington Security Slot Setting up Your MonitorSetting up an Ergonomic Workstation Or graphics card Connecting Your LCD MonitorJack to the DC power port on the back of your monitor Successfully installedCard Connecting Your Multimedia LCD MonitorName Description Attached power MIC OUT jackWindows Installing the Video DriverPlug and Play PROPERTIES, Monitor tab, have Disk Self-Test Feature Check StfcVersion 4.00.950A Version 4.00.950BMonitor Getting HelpWarm-up Time User Controls Adjusting Your LCD MonitorAutomatic Save Direct-Access FeaturesAuto Adjustment OSD Lock/Unlock Setting slidebar Numeric value IndicatorOn Screen Display OSD BrightnessBrightness Contrast Accessing the menu systemOSD functions and adjustments Position Color Control ResetTemperature ColorTime LanguageMenu Position Menu DisplayDisplay Mode This screen shows the horizontal and vertical Audio Controls Adjusts the volume of the low soundLeft Decrease volume Right Increase volume Adjusts the volume of the high soundAppendix PowerSaverTroubleshooting Move the computer’s mouse or Screen is blank Monitor is using its power PowerSaverDisplay Mode Management systemCheck the volume control on Documentation Troubleshooting problems AudioConnecting your Raise the volume Sound level isYour computer or sound Speciﬁcations DDC Data Horizontal Sync Not used Vertical Sync DDC Clock Pin D-sub connectorPin Assignments Red Green Green + H/V Sync BlueDisplay Modes Preset timing modesDisplay Mode Horizontal Vertical Pixel Clock Sync Polarity Screen Turn off your monitor and unplug its power cordChanging the Base Removing the baseRear cover mounting pad Mounting interface pad Maintenance of Your LCD monitorAttaching a base Index MPR II Compliance Regulatory InformationFCC Information IC Compliance NoticeCanada Printed on recyclable paper