Samsung LTN406W manual Venus-01-en 6/28/03 814 AM

Page 3

venus-01-en 6/28/03 8:14 AM Page 2

•Protect the power cord. Power supply cords should be routed so that they won’t be walked on or pinched by objects placed on or against them. Pay particular attention to cords at plugs, convenience receptacles, and the point where they exit from the unit.

•Unplug the TV from the wall outlet and disconnect the antenna or cable system during a lightning storm or when left unattended and unused for long periods of time.

This will prevent damage to the unit due to lightning and power-line surges.

•Avoid overhead power lines. An outside antenna system should not be placed in the vicinity of overhead power lines or other electric light or power circuits or where it can fall into such power lines or circuits. When installing an outside antenna system, be extremely careful to keep from touching the power lines or circuits. Contact with such lines can be fatal.

•Do not overload the wall outlet or extension cords. Overloading can result in fire or electric shock.

•Do not insert anything through the openings in the unit, where they can touch dangerous voltage points or damage parts. Never spill liquid of any kind on the TV.

•Ground outdoor antennas. If an outside antenna or

cable system is connected to the TV, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No.70-1984, provides information about proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

•Do not attempt to service the TV yourself. Refer all servicing to qualified service personnel. Unplug the unit from the wall outlet and refer servicing to qualified service personnel under the following conditions:

-when the power-supply cord or plug is damaged

-if liquid has been spilled on the unit or if objects have fallen into the unit

-if the TV has been exposed to rain or water

-if the TV does not operate normally by following the operating instructions

-if the TV has been dropped or the cabinet has been damaged

-when the TV exhibits a distinct change in performance

•If you make adjustments yourself, adjust only those controls that are covered by the operating instructions. Adjusting other controls may result in damage and will often require extensive work by a qualified technician to restore the TV to normal.

•When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or those that have the same characteristics as the original part. Unauthorized substitutions may result in additional damage to the unit.

•Upon completion of any service or repairs to this TV, ask the service technician to perform safety checks to determine that the TV is in a safe operating condition.

SAFETY 2

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Owner’s Instructions Thank You for Choosing Samsung Venus-01-en 6/28/03 814 AM Risk of Electric Shock do not Open FCC Information Venus-01-en 6/28/03 814 AM Operation InstallationSpecial Features Your New TVTroubleshooting PC DisplayAppendix List of Parts List of FeaturesFamiliarizing Yourself with Your New TV Front Panel ButtonsVOL + Rear Panel Jacks Remote Control CH and CH Channel Up/DownVOL + and VOL DNIe Button +100Remote control doesn’t work Installing Batteries in the Remote ControlAntennas with 300-ohm Flat Twin Leads Connecting VHF and UHF AntennasCable without a Cable Box Connecting Cable TVAntennas with 75-ohm Round Leads Separate VHF and UHF AntennasConnecting to a Cable Box that Descrambles Some Channels Connecting to a Cable Box that Descrambles All ChannelsEnglish-10 Connecting a VCR Connecting an External Input Source Connecting an S-VHS VCRConnecting a Digital TV Set-Top Box Connecting a DVD PlayerConnecting the Speakers How to ConnectHow to Turn the Sound On SUB Connecting a PCTurning the TV On and Off Adjusting the VolumeUsing the Channel Buttons Using the PRE-CH Button to select the Previous ChannelUsing Mute Viewing the DisplayViewing the Menus Setting Up the Remote to Operate Your VCR Setting Up Your Remote ControlSetting Up the Remote to Operate Your Cable Box Setting Up the Remote to Operate Your DVD Remote Control Codes Chapter Four Plug & Play FeatureMemorizing the Channels Selecting the Video Signal-sourceTo select channels over Storing Channels in Memory Automatic MethodAdding and Erasing Channels Manual Method To Select TV/InputTo Edit the Input Source Name Alternate method Using Automatic Picture SettingsCustomizing the Picture Using Automatic Sound Settings Customizing the Sound Selecting a Menu Language Setting the Blue Screen Mode To Select an External Output Device LNA Low Noise Amplifier Fine Tuning Channels PIP Settings Viewing Picture-in-PictureActivating Picture-in-Picture Swapping the Contents of the PIP and Main image Changing the PIP ChannelChanging the Size of the PIP Window Freezing the Picture Changing the Screen SizeAdjusting the Background Color Setting the DNIe Turning the Dolby Pro-Logic II On To Enjoy Dolby Digital SoundTurning the Dynamic Range On Speaker Speaker SettingsLevel Time Delay Trademark & Label License Notice Changing the Stereo Settings Selecting the Main or Sub Sound You can select either Main or Sub when PIP is OnTo Select an External Input Device Adjusting the Headphone Sound Setting the Clock Setting the On/Off Timer What is Absent Power Off? Setting the On/Off Timer Using the Menu Setting the Sleep TimerSetting Up Your Personal ID Number PIN Using the V-ChipHow to Set up Restrictions Using the ‘TV guidelines’ How to Enable/Disable the V-ChipTV-Y English-58 NC-17No children under age Adults only NR Not rated How to Set up Your PC Software Windows only Using Your TV as a Computer PC DisplayAdjusting the Screen Quality Changing the Screen Position To Initialize the Screen Settings Use to return the screen settings to the default valuesHow to DVI Select Choose the right DVI signal for your computerHow to Auto Adjust Chapter Six Identifying ProblemsEnglish-67 Maintenance of Your LCD TV Installing StandOptional Using the Anti-Theft Kensington LockList of Contents How to Attach the LCD TV to the Bracket Cleaning and Maintaining Your TV Using Your TV in Another CountryPin Assignments LTN325W LTN406W SpecificationsClock Sync Polarity Mode Display ModesFrequency KHz MHz
Related manuals
Manual 81 pages 50.35 Kb
Top Page Image Contents