Chapter Two
IN S TA L L AT I O N
Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like this, see “Antennas with
If your antenna has one lead that looks like this, see “Antennas with
If you have two antennas, see “Separate
VHF and UHF Antennas” on page 8.
Antennas with 300-ohm Flat Twin Leads
If you are using an
1
Place the wires from the twin leads under the screws on a 300- 75 ohm adaptor (not supplied). Use a screwdriver to tighten the screws.
2
Plug the adaptor into the TV ANTENNA terminal on the bottom of the back panel.