Samsung LN32B460 Connections LN22B460, Connecting VHF and UHF Antennas, Connecting Cable TV

Connections (LN22B460)

¦Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like the diagram to the right, see ‘Antennas with 300 Ω Flat Twin Leads’ below.

If your antenna has one lead that looks like the diagram to the right, see ‘Antennas with 75 Ω Round Leads’.

If you have two antennas, see ‘Separate VHF and UHF Antennas’.

Antennas with 300 Ω Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or ‘rabbit ears’) that has 300Ω twin flat leads, follow the directions below.

1.Place the wires from the twin leads under the screws on a 300-75 Ω adapter (not supplied). Use a screwdriver to tighten the screws.

2.Plug the adaptor into the ANT IN terminal on the back of the TV.

Antennas with 75 Ω Round Leads

Plug the antenna lead into the ANT IN terminal on the back of the TV.

Separate VHF and UHF Antennas

If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before connecting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics shops).

1.Connect both antenna leads to the combiner.

2.Plug the combiner into the ANT IN terminal on the bottom of the rear panel.

ANT IN

ANT IN

UHFVHF

ANT IN

UHF

VHF

¦Connecting Cable TV

To connect to a cable TV system, follow the instructions below.

Cable without a Cable Box

Plug the incoming cable into the ANT IN terminal on the back of the TV.

NBecause this TV is cable-ready, you do not need a cable box to view unscrambled cable channels.

ANT IN

Connecting to a Cable Box that Descrambles All Channels

1.Find the cable that is connected to the ANT OUT terminal on your cable box. N This terminal might be labeled ‘ANT OUT’, ‘VHF OUT’ or simply, ‘OUT’.

2.Connect the other end of this cable to the ANT IN terminal on the back of the TV.

ANT IN ANT OUT

ANT IN

English -