Safety & Care
IMPORTANT: Be sure not to place your Samsung Fliptop powered by DIRECTV® near anything WET or HOT!
ivSafety & Care
•To prevent electrical shock, this apparatus shall be connected to a mains socket outlet with a protective earthing and fully inserted.
•Avoid audio hum or interference by inserting all cable plugs firmly into their jacks. Also, place Audio/Video (A/V) cables to the sides of the LCD rather than down the middle once connected. Try not to coil any
•Never insert objects of any kind into any openings in the Samsung Fliptop powered by DIRECTV® (other than the DIRECTV® Access Card as detailed in this chapter).
•Place it on a flat, hard surface — do not operate the Samsung Fliptop powered by DIRECTV® on a carpet or other padded surface.
•Always unplug your Samsung Fliptop powered by DIRECTV® before moving it.
•Leave the main power connector accessible the mains connector at the back of the unit in case of emergency shutdown
•CAUTION: Electric Shock — never attempt to disassemble the Samsung Fliptop powered by DIRECTV® yourself; always take it to a qualified service person when repair is required. Opening or removing covers may expose dangerous voltage or other risks, and incorrect reassembly can cause shock when receiver is subsequently used. Attempted
•Do not drop your Samsung Fliptop powered by DIRECTV® and always move it with care.
•Have your Samsung Fliptop powered by DIRECTV® professionally serviced (do not attempt to service it yourself)
•Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
•Do not use near water. accident may occur due to humidity such as short and electrical shock. Also, it shall not be exposed to frying oil.
•If smoke occurs or fumes smell during stop operation. then, promptly stop power source and remove plug. After this, contact service center.
•Pay attention to touch LCD with head during use.
For your information:
The identification sticker can be located underneath or on the back of your receiver. The telecommunication network voltage used is the category number 3.