Remote Control Buttons

Press to pause the current screen.

Activates picture in picture.

Confirms a selection.

Displays the main on-screen menu.

Press to select a preset time interval for automatic shutoff.

Use it to adjust volume.

Press to mute the PDP sound.

Press to change the screen size.

Turns the PDP on and off.

RemoteControl

ŒPOWER button

´ASPECT button

ˇNumber buttons ¨+100 button

Press to select channels over 100. For example, to select channel 121, press “+100”, then press “2” and “1.”

ˆMUTE button

ØVOL (Volume) buttons ∏SLEEP button

”MENU button ’ENTER button

˝PIP button

ÔSTILL button LED Display

When you press a button, ‘‘ appears along with selected mode (TV, VCR, CATV, DVD or STB) and remaining batteries on LED.

ÒP.MODE button

Adjust the PDP picture by selecting one of the preset factory settings (or select your personal, customized picture settings.)

ÚMODE button

Selects a target device to be controlled by the Samsung remote control (ie., VCR, Cable, DVD players or STB). If you change modes, the new mode is momentarily displayed on LED.

ÆPRE-CH button

Tunes to the previous channel.

ıTV/VIDEO button

Press to display all of the available video sources

(ie., Video, S-Video, Component1, Component2, PC, DVI).

˜CH (Channel) buttons

Use it to switch channels.

¯INFO button

Press to display information on the PDP screen.

˘EXIT button

Press to exit the menu.

¿Up/Down Left/Right buttons

12Control the cursor in the menu.

¸SURROUND button

Press the hear the Dolby surround effect.

˛MTS button

Press to choose stereo, mono or Separate Audio Pro- gram (SAP broadcast).

◊AUTO PROG. button

The TV automatically cycles through all of the avail- able channels and stores them in memory.

±ADD/DEL button

Press to add or delete channels in the TV’s memory.

≠DNIe button

Activates DNIe (Digital Natural Image engine).

–CAPTION button

Controls the caption decoder.

—SET button

Used during set up of this Samsung remote control, so that it will work compatibly with other devices (VCR, cable box, DVD)

÷PIP control buttons

SWAP	: Exchanges the video signal that is currently
	displayed on the main screen with the
	signal in the PIP window.
SIZE	: Press to make the PIP window Large, Small
	or Double.

CH▲,▼ : Displays the available channels in sequence. (These buttons change channels in the PIP window only).

®VCR, DVD control buttons

Controls VCR tape or DVD disc functions: Stop,

Rewind, Play/Pause, Fast Forward.

∑RESET button

If your remote control is not functioning properly, take out the batteries and press the reset button for about 2~3 seconds. Re-insert the batteries and try using the remote control again.

Installing the Batteries in Your Remote Control

Slide the back cover	Install two AAA size batter-	Slide the cover back into
1to open the battery	2ies. Make sure to match the	3place.
compartment of the	“+” and “-” ends of the bat-
remote control.	teries with the diagram
	inside the compartment.

Remote Control Operation Range.

You can use your remote control within a distance of 23 feet and an angle of 30 degrees

from the left and right sides of the PDP’s remote control receiver.