Samsung SPN4235 manual Wall Installation Instructions, Installation Notes, Wall attachment panel

Page 8

Wall Installation Instructions

Installation Notes

1 Do not install the PDP in any location other than a vertical wall.

To protect the performance of the PDP and prevent problems, avoid the following

2 places.

•Do not install next to smoke and fire detectors.

•Do not install in an area subjected to vibration.

•Do not install in an area subjected to high voltage.

•Do not install near or around any heating apparatus.

3 Use only recommended parts and components.

Parts (Wall attachment panel is sold separately. Check with your dealer)

Wall attachment panel

Insulation holders ; 4 EA

Screws ; 4 EA

14

Fixing the PDP panel to the wall attachment panel bracket

1 Remove the screws on the rear of the PDP panel.

Removing four screws

2 Connect Insulation holders to screws. (see the illustration below)

3 Tighten the screws connected to the Insulation holders on the rear of the PDP panel.

Connecting four screws

15

Image 8

Contents Owner’s Instructions Important Safety Information Thank You for Choosing SamsungFCC Information Table of Contents User InstructionsGeneral Information Your New Plasma Display Panel Remote Control Buttons Wall Installation Instructions Installation NotesWall attachment panel Insulation holders 4 EAChangeing the angle How to Adjust Mounting AngleFactory default Connections Connecting VHF and UHF Antennas Connecting Cable TVAntennas with 75-ohm Round Leads Cable without a Cable BoxConnecting Speakers How to ConnectConnecting a VCR Connecting a CamcorderConnecting a VCR to the Video or S-Video/Audio jack Viewing camcorder tapesPlaying DVD Watching DTVTo Play DVD To Watch DTVOperation Turning the PDP On and Off Viewing the Menus and DisplaysViewing the Menus Displaying Status InformationSelecting the Video Signal-source Memorizing the ChannelsTo View Memorized Channel PIP Mode Setting Up Your Remote Control Adjusting the VolumeUsing Mute Changing ChannelsVCR Codes Cable Box Codes DVD Codes Remote Control CodesPicture Control Using Automatic Picture Settings Customizing the PicturePress the Menu button, then press the Enter Button Press the Menu button to exitSelecting the Color Tone DNIe Digital Natural Image enginePress the UP or Down button to select Source Viewing the Picture-in-PictureSelecting the PIP Screen Changing the Size of the PIP Window Changing the Location of the PIP Image STD, HRD or IRCChanging the Screen Size Sound Control Customizing the Sound Using Automatic Sound Settings Volume Button to select Sound, then press the EnterPress the UP or Down button to select Auto Press the Left or Right button to select Mono Stereo or SAPUsing Dolby Virtual Using a SubwooferChannel Control Fine Tuning Channels LNA Low Noise AmplifierConnecting a PC and Operation Connecting to a PC Pin ConfigurationSetting up Your PDP Plug and Play To watch the PC screenHow to Set up Your PC Software Windows only 75.000 37.500Adjusting the PC Screen Adjusting the R.G.BCustom. When Custom is selected, the word Color Adjust will appear on the screenVertical, horizontal frequencies and resolution Changing the Size of the Image InformationTion, then press the Enter button AppearCoarse Adjustment Picture Quality AdjustmentPicture Automatic Adjustment Remove picture noise on the screen by pressing Time SettingFine Tuning Fine Press the UP or Down button to select Sleep Setting the Clock Setting the Sleep TimerButton to select Function, then press the Enter Setting the Timers Setting the On/Off TimerSetting the Preferred Channel and Volume Level Function DescriptionSelecting a Menu Language Viewing Closed Captions Digital Noise Reduction Setting Auto Power OffPower Off Using the V-Chip How to Enable/Disable the V-ChipHow to Set up Restrictions Using the TV guidelines Mpaa Rating Selecting the Film Mode AppendixTroubleshooting Care and Maintenance Specifications Memo