Samsung PS-42S5S Installing the Display on the Wall Attachment Panel, Direction of the arrow

Page 10

Installing the Display on the Wall Attachment Panel

➢Refer to the correct installation guide according to your wall bracket.

Installation Notes

◆Contact a technician for installing the wall bracket.

◆Samsung Electronics is not responsible for any damages to the product or harm to customers when the installation is done by the customer.

◆This product is for installing on cement walls. The product may not stay in place when installed on plaster or wood.

Components

◆Only use the components and accessories shipped with the product.

	Wall Bracket	Hinge			Accessories
					Plastic Hanger: 4	Screw : 11
	1	Left: 1	Right: 1		Screw : 4	Anchor : 11
	1	Left: 1	Right: 1
Wall Bracket Assembly
1	Insert and tighten the Captive Screw in			2	Before drilling into the wall, check if the length
	the direction of the arrow.				between the two locking holes at the back of
	When done, mount the wall bracket on				the product is correct.
	the wall.				If the length is too short or long, loosen all or
	Captive Screw				some of the 4 screws on the wall bracket to
	Captive Screw				adjust the length.

	Length between the
	two locking holes
Wall Bracket
Hinge (Left)
There are two hinges
(left and right). Use the
correct one.	Hinge (Right)
	Hinge (Right)

3 Check the installation diagram and mark the drill points on the wall. Use the 5.0 mm bit to drill holes deeper than 35 mm.

Fix each anchor in the corresponding hole. Match each of the brackets and hinge holes to the corresponding anchor holes and insert and tighten the 11 screws .

English - 10

Image 10

Contents PDP-TELEVISION User Instructions Video Cable Power CordOwner’s Instructions PC CableContents Symbols Control Panel Front of the TVRear Panel For further details about connection, refer to pages 58~63Infrared Remote Control Inserting the Batteries in the Remote Control Assembling the Stand-BaseAdjust the length Installing the Display on the Wall Attachment PanelWall Bracket Hinge Accessories Plastic Hanger Screw Insert and tighten the Captive ScrewSee the figure below Stay in place after installationInsert the screw into the plastic hanger Left and right plastic hangersUsing a coaxial cable Connecting to an Aerial or Cable Television NetworkConnecting a Satellite Receiver or Decoder Rear of the TVTo switch your television off, press the power button again Switching Your Television On and OffMains lead is attached to the rear of your television Change channels and adjust the volume Familiarizing Yourself with the Remote ControlTheir functions Plug & Play Feature Press the Enter button to set the clockPress the Menu button Result The main menu is displayed For further details on settings, refer to the previousChoosing Your Language Press the Enter buttonStoring Channels Automatically Select your Country by pressing the … or † buttonStoring ChannelsManually AutoChannel mode Skipping Unwanted Channels Sorting the Stored Channels This operation allows you to change the programme numbersAssigning Names to Channels Locking the Channel Using the LNA Low Noise Amplifier Feature Fine Tuning Channel Reception Displaying Information Changing the Picture StandardResult Following options are available Customizing the Picture SettingsTint Ntsc only Setting the Picture PC Mode Preset to the PC mode by pressing the Source buttonSetting the Picture PC Mode Positioning and Sizing the screen using Zoom Selecting the Picture SizeViewing the DNIe Demonstration Freezing the Current PictureEmphasizing mild greens Setting the My Colour Control Easy ControlEmphasizing clear blues Emphasizing warm skin coloursSetting the My Colour Control Detail Control Setting the Blue Screen Using the Colour Weakness Enhancement Feature Using the Energy Saving Feature Viewing the Picture in Picture PIP TV Ext.1 Ext.2 AV S-VideoTvpip PIP Buttons Feature Easy functions of the remote controlTable of PIP Settings Using the Digital NR Noise Reduction Feature Preventing Screen Burn-in Horizontal Dot Vertical Line TimeReducing the Effects of Screen Burn Changing the Sound Standard Standard Music Movie Speech CustomCustomizing the Sound Settings Adjusting the Volume AutomaticallySetting the TruSurround XT Off 3D Mono StereoSetting the Melody Sound Selecting the Internal MuteSelecting the Sound Mode depending on the model Setting and Displaying the Current Time Setting the Sleep Timer Switching the Television On and Off Automatically Auto Power Off Viewing an External Signal Source Hdmi on the TV’s rear panelRedirecting an Input to the External Output Teletext Feature Part ContentsDisplaying the Teletext Information Press the TTX/MIX button againSelecting Display Options To display PressSelecting a Teletext Input/Output Specification Connecting to External Input/OutputInput Connecting to the AV Output Connecting to the RCA Input Connecting to the S-Video InputConnecting to the Component Input Connecting to the PC InputConnecting to the HDMI/DVI Compatible Connecting to the Hdmi InputHDMI/DVI in connector is used for equipment with a DVI out Connecting the Home Theater System Connecting Home Theater SystemTo Display the DVD Home Theater Setting up Your PC Software Windows only Input Mode PC Video Signal Resolution Vertical HorizontalSamsung Your TV comes equipped with a universal remote control.Remote control might not be compatible with all VCRs, DVD players, Cable boxes, and Set-Top BoxsProgramming the Remote Control for Other Components Check the volume Power buttonCheck the picture contrast and brightness settings Normal picture but no sound Check the volumeMemo Memo Memo After Sales Service Correct Disposal of This Product