Programming
the
Remote,
(
Continued
)
C. Standard Set-Up:
Step 1: Turn on the device ( TV, VCR, Cable Box, Satellite Receiver, etc. ) that you wish to operate.
Step 2: On the Star Light universal remote control, press the corresponding DEVICE button (TV, VCR,CATV, SAT,Audio,or Aux) and the MUTE button simultaneously.
Note:
SET
will appear in the LCD.
Step 3: Locate the three digit code number for your brand of equipment from the code lists found on pp. (15
31). Example: TV
Note: If the brand list contains more than one code number, select the first code listed.
Step 4: Point the remote control at the devise turned on in Step1 and press in the three digit code number selected in Step 3.
Note:
SET # # #
will appear in the LCD.
Your device will turn off when the correct code has been selected. If the device fails to turn off, go back to Step 3 and select the next three digit code for your equipment, and press in the code number.
Note: Repeat the above step until the device turns off. When the device turns off proceed to Step 5.
Step 5: Press the DEVICE button (TV, VCR, CATV, SAT, Audio, Aux) on the remote control to store the three digit code that turned off your equipment.
Note:
PASS
will flash in the LCD indicating that the code has been stored.
Step 6: Test the remote control functions with the code just stored.
Example: Power, Channel Up, Volume Up, etc. If any of the buttons do not perform as they should, please repeat from Step 2 using the next three digit code until the right code is found.
Step 7: To program other devices into the corresponding Device button of the remote control, repeat the above steps with the respective devices and Device buttons.
7