Advanced Features | Universal Remote Control SL-7000 specs

AdvancedFeatures

A. Three Digit Code Number Recall:

If you wish to find a code number that has been stored in your remote control, please use the following steps:

Step 1: On the remote control, press the DEVICE and MUTE buttons simultaneously.

Note:SET will appear in the LCD.

Step 2: Press the INPUT button. The LCD will flash the three digit code number for five seconds before returning to its original sate.

B. Storing Multi-Commands/Favorite Channels to Memory Buttons

Memory buttons M1, M2, M3 and M4 can be set up to store up to six(6) commands with one button push. Any functions, in any Device mode (except Channel up and Channel down), can be stored in any one of the four memory buttons.

This will enable you, for example, to turn on the TV and Satellite receiver and select a preassinged satellite channel with only one button push.

Method of setting up:

Step 1: Press the Device button (TV, VCR, CATV, SAT, AUX, AUDIO) and MUTE button, simultaneously.

Note:SET will appear in the LCD.

Step 2: Press one of the memory buttons(M1-M4) that you would like to designate for multi-command or favorite channel operation.

Note:M (1-4) will appear in the LCD. The memory button is now ready to be set up.

Step 3: Press up to six commands that you would like to store in the memory button.

Note: Each successive selection will appear as 1~6 in the LCD.

Step 4: Press the Channel(+) button to store your selection.

Note:SAVE will flash twice and the Device mode will appear in the LCD.

Please repeat the above steps for the remaining memory buttons.